Water hardness in Cedar Park, TX

Water in Cedar Park is very hard, with a median of 351 mg/L (20.5 grains per gallon) across 16 monitoring sites within 10 miles.

81% harder than the Texas median (194 mg/L) 23rd hardest of 251 Texas towns Population 77,516
351mg/L
20.5 grains per gallon
Very hard

Cedar Park tap water at a glance

  • HardnessVery hard (351 mg/L, 20.5 gpg, local measurements). Water softeners are common at this level.Size a water softener →
  • PFAS1 found in EPA testing; every result with a federal limit was at or below it.PFAS results →
  • Lead pipesNo lead service lines reported.Details →
  • ViolationsNo health-based violations since 2016.EPA record →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 351 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 20.5 gpg (19.7 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites16
Lab samples64
Sample years2000–2018
Middle 50% of sites293–401 mg/L
Groundwater (wells, springs)363 mg/L · 15 sites
Surface water (rivers, lakes)175 mg/L · 1 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Cedar Park

Prefilled with Cedar Park's measured local hardness of 351 mg/L (20.5 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Cedar Park tap water

City of Cedar Park is the main public water system for Cedar Park. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 8 samples taken May 2024 – May 2025. 1 PFAS was detected.

ChemicalHighest resultDetected inEPA limit
PFBA
perfluorobutanoic acid
5 ppt 1 of 8 samples —

Other water systems serving parts of Cedar Park

Water systemPFAS detectedHighest PFOA / PFOSTested
City of Austin Water & Wastewater
serves over 10,000 people
PFBA, PFHxS, PFBS +3 more ND / 4.8 ppt Oct 2023 – Jul 2024
Manville WSC
serves over 10,000 people
PFNA, PFOS, PFBS +7 more 5.9 / 12.4 ppt Feb 2023 – Nov 2023
North Austin MUD 1
serves over 10,000 people
None detected — Aug 2023 – May 2024
City of Georgetown
serves over 10,000 people
PFBA, PFPeA, PFHxA +4 more 4.9 / 5.7 ppt Jun 2023 – Feb 2025
City of Leander
serves over 10,000 people
PFBA — May 2024 – May 2025

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Cedar Park

City of Cedar Park reported 22,696 service lines (the pipes connecting homes to the water main) in its inventory. It reported no lead or galvanized lines requiring replacement.

0lead (0%)
0galvanized requiring replacement
0unknown material (0%)
22,696not lead (100%)

Other water systems serving parts of Cedar Park

Water systemService linesTotal
City of Austin Water & Wastewater0 lead · 777 galvanized · 0 unknown257,784
Manville WSC0 lead · 0 galvanized · 0 unknown12,511
North Austin MUD 10 lead · 0 galvanized · 0 unknown2,657
City of Georgetown0 lead · 161 galvanized · 4 unknown62,099
City of Leander0 lead · 0 galvanized · 6,716 unknown26,978

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Cedar Park drinking water violations

EPA records show no health-based violations for City of Cedar Park since 2016. It also had 2 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Other water systems serving parts of Cedar Park

Water systemHealth-based violationsMonitoring/reporting
City of Austin Water & Wastewater50
Manville WSC56
North Austin MUD 1None0
City of Georgetown12
City of LeanderNone10

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Cedar Park

SiteTypeDistanceMedianSamplesYears
ZK-58-26-808
USGS Texas Water Science Center
Well 0.9 mi474 mg/L12008
ZK-58-34-210
USGS Texas Water Science Center
Well 1.4 mi317 mg/L12008
ZK-58-34-309
USGS Texas Water Science Center
Well 3 mi393 mg/L12008
ZK-58-34-621
USGS Texas Water Science Center
Well 5 mi371 mg/L12008
ZK-58-35-112
USGS Texas Water Science Center
Well 5.1 mi272 mg/L42007–2011
ZK-58-27-721
USGS Texas Water Science Center
Well 5.8 mi363 mg/L12008

Water hardness in towns near Cedar Park

TownDistanceMedianClass
Brushy Creek5 mi 356 mg/LVery hard
Leander5 mi 340 mg/LVery hard
Wells Branch9 mi 370 mg/LVery hard
Round Rock10 mi 366 mg/LVery hard
Lago Vista11 mi 254 mg/LVery hard
Liberty Hill12 mi 322 mg/LVery hard
Georgetown13 mi 326 mg/LVery hard
Pflugerville14 mi 332 mg/LVery hard
Lakeway15 mi 206 mg/LVery hard
Austin15 mi 93 mg/LModerately hard

Williamson County

Cedar Park is in Williamson County, where the median is 322 mg/L (very hard) across 20 sites.

See all of Williamson County →

Texas

The statewide median is 194 mg/L (very hard) from 2,271 sites.

Texas hardness map →

Cedar Park, TX water: common questions

Do I need a water softener in Cedar Park?

Very likely. Water measured around Cedar Park is 20.5 gpg (351 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 36,000 grains.Size it for your household →

Who supplies Cedar Park's drinking water?

The main public water system serving Cedar Park in EPA records is City of Cedar Park. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Cedar Park?

It depends on what you want to remove. In Cedar Park, EPA testing found PFBA in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS. On the other hand, no lead service lines reported and no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next