Water hardness in Azle, TX

Water in Azle is very hard, with a median of 355 mg/L (20.7 grains per gallon) across Tarrant County.

83% harder than the Texas median (194 mg/L) 21st hardest of 251 Texas towns Population 14,562
355mg/L
20.7 grains per gallon
Very hard

There are not enough monitoring sites within 10 miles of Azle, so this page uses the Tarrant County median.

Azle tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 355 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 20.7 gpg (19.9 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites59
Lab samples940
Sample years2000–2023
Middle 50% of sites139–375 mg/L
Groundwater (wells, springs)370 mg/L · 30 sites
Surface water (rivers, lakes)140 mg/L · 29 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Azle

Prefilled with Azle's measured local hardness of 355 mg/L (20.8 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Azle tap water

City of Azle is the main public water system for Azle. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Dec 2024 – Sep 2025. 2 PFAS were detected.

ChemicalHighest resultDetected inEPA limit
PFBA
perfluorobutanoic acid
5.8 ppt 4 of 4 samples —
PFPeA
perfluoropentanoic acid
3 ppt 1 of 4 samples —

Other water systems serving parts of Azle

Water systemPFAS detectedHighest PFOA / PFOSTested
Community WSC
serves 10,000 people or fewer
PFBA — Feb 2024 – Mar 2025

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Azle

City of Azle reported 6,223 service lines (the pipes connecting homes to the water main) in its inventory. It reported no known lead lines, but 265 lines are still of unknown material.

0lead (0%)
0galvanized requiring replacement
265unknown material (4%)
5,958not lead (96%)

Other water systems serving parts of Azle

Water systemService linesTotal
Community WSC0 lead · 0 galvanized · 0 unknown1,543

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Azle drinking water violations

EPA records show no health-based violations for City of Azle since 2016.

Other water systems serving parts of Azle

Water systemHealth-based violationsMonitoring/reporting
Community WSC12

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Azle

SiteTypeDistanceMedianSamplesYears
XU-19-42-614
USGS Texas Water Science Center
Well 2.4 mi12 mg/L12016

Water hardness in towns near Azle

TownDistanceMedianClass
Saginaw10 mi 366 mg/LVery hard
White Settlement11 mi 370 mg/LVery hard
Fort Worth14 mi 128 mg/LHard
Benbrook16 mi 370 mg/LVery hard
Haltom City16 mi 110 mg/LModerately hard
Weatherford17 mi 348 mg/LVery hard
Watauga17 mi 168 mg/LHard
Keller18 mi 138 mg/LHard
North Richland Hills19 mi 168 mg/LHard
Roanoke20 mi 140 mg/LHard

Tarrant County

Azle is in Tarrant County, where the median is 355 mg/L (very hard) across 59 sites.

See all of Tarrant County →

Texas

The statewide median is 194 mg/L (very hard) from 2,271 sites.

Texas hardness map →

Azle, TX water: common questions

Do I need a water softener in Azle?

Very likely. Water measured around Azle is 20.7 gpg (355 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 36,000 grains.Size it for your household →

Who supplies Azle's drinking water?

The main public water system serving Azle in EPA records is City of Azle. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Azle?

It depends on what you want to remove. In Azle, EPA testing found PFBA and PFPeA in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS. On the other hand, no lead service lines reported and no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next