Water hardness in Westminster, MD

Water in Westminster is moderately hard, with a median of 114 mg/L (6.6 grains per gallon) across 12 monitoring sites within 10 miles.

104% harder than the Maryland median (56 mg/L) 38th hardest of 121 Maryland towns Population 20,536
114mg/L
6.6 grains per gallon
Moderately hard

Westminster tap water at a glance

  • HardnessModerately hard (114 mg/L, 6.6 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
  • PFAS8 found; the highest PFOA and PFOS result was above EPA's 4 ppt limit (a single result is not a violation).Filters that remove PFAS →
  • Lead pipesNo lead service lines reported.Details →
  • Violations4 health-based violations since 2016.What they were →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 114 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 6.6 gpg (6.4 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites12
Lab samples18
Sample years2000–2022
Middle 50% of sites90–209 mg/L
Groundwater (wells, springs)110 mg/L · 10 sites
Surface water (rivers, lakes)210 mg/L · 2 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Westminster

Prefilled with Westminster's measured local hardness of 114 mg/L (6.7 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Westminster tap water

City of Westminster is the main public water system for Westminster. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 28 samples taken Jan 2023 – Sep 2025. 8 PFAS were detected. The highest PFOA and PFOS results were above EPA's drinking water limit (4 ppt).

ChemicalHighest resultDetected inEPA limit
PFPeA
perfluoropentanoic acid
66.7 ppt 12 of 28 samples —
PFHxA
perfluorohexanoic acid
24.6 ppt 11 of 28 samples —
PFBA
perfluorobutanoic acid
20.1 ppt 4 of 28 samples —
PFOA
perfluorooctanoic acid
12.4 ppt 10 of 28 samples 4 ppt
PFBS
perfluorobutane sulfonic acid
8.6 ppt 15 of 28 samples —
PFHpA
perfluoroheptanoic acid
8.1 ppt 6 of 28 samples —
PFOS
perfluorooctane sulfonic acid
6.9 ppt 4 of 28 samples 4 ppt
PFHxS
perfluorohexane sulfonic acid
4.2 ppt 7 of 28 samples 10 ppt*

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Westminster

City of Westminster reported 0 service lines (the pipes connecting homes to the water main) in its inventory. It reported no lead or galvanized lines requiring replacement.

0lead (—)
0galvanized requiring replacement
0unknown material (—)
0not lead (—)

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Westminster drinking water violations

EPA records show 4 health-based violations for City of Westminster since 2016, all since resolved or closed. The most recent began in Apr 2018. It also had 3 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Contaminant or ruleTypeViolationsMost recentStatus
Total trihalomethanes (TTHM)
byproducts formed when chlorine reacts with natural matter in water · what it means
highest measured 87 UG/L; limit 0.080 mg/L
Contaminant above legal limit 4 Apr 2018 Resolved/closed

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Westminster

SiteTypeDistanceMedianSamplesYears
CL Cd 181
USGS Maryland Water Science Center
Well 1.5 mi465 mg/L32002–2019
LITTLE PIPE CREEK AT AVONDALE, MD
USGS Maryland Water Science Center
Stream 2.2 mi208 mg/L22022
CL Cd 180
USGS Maryland Water Science Center
Well 4.2 mi231 mg/L12014
CL Be 120
USGS Maryland Water Science Center
Well 4.5 mi76 mg/L32014–2019
CL Ad 48
USGS Maryland Water Science Center
Well 6.2 mi117 mg/L12007
CL Ad 47
USGS Maryland Water Science Center
Well 6.2 mi110 mg/L12006

Water hardness in towns near Westminster

TownDistanceMedianClass
Eldersburg12 mi 61 mg/LModerately hard
Reisterstown13 mi 78 mg/LModerately hard
Owings Mills17 mi 76 mg/LModerately hard
Randallstown18 mi 70 mg/LModerately hard
Milford Mill20 mi 78 mg/LModerately hard
Mays Chapel21 mi 216 mg/LVery hard
Pikesville21 mi 237 mg/LVery hard
Cockeysville21 mi 216 mg/LVery hard
Lochearn22 mi 138 mg/LHard
Ellicott City23 mi 76 mg/LModerately hard

Carroll County

Westminster is in Carroll County, where the median is 86 mg/L (moderately hard) across 16 sites.

See all of Carroll County →

Maryland

The statewide median is 56 mg/L (soft) from 1,412 sites.

Maryland hardness map →

Westminster, MD water: common questions

Do I need a water softener in Westminster?

Probably not. Water measured around Westminster is 6.6 gpg (114 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable. If spotting bothers you, about 12,000 grains of capacity covers a 3-person home between weekly regenerations.Size it for your household →

Who supplies Westminster's drinking water?

The main public water system serving Westminster in EPA records is City of Westminster. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Westminster?

It depends on what you want to remove. In Westminster, EPA testing found PFPeA, PFHxA and PFBA and 5 other PFAS in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS; the system had 4 health-based violations since 2016, for TTHM; the utility's annual report says what was done about them. On the other hand, no lead service lines reported. A water softener is not a filter.Filters that remove PFAS →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next