Water hardness in Owings Mills, MD
Water in Owings Mills is moderately hard, with a median of 76 mg/L (4.4 grains per gallon) across 54 monitoring sites within 10 miles.
Owings Mills tap water at a glance
- HardnessModerately hard (76 mg/L, 4.4 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 76 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 4.4 gpg (4.3 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Owings Mills
Prefilled with Owings Mills's measured local hardness of 76 mg/L (4.4 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Owings Mills tap water
Owings Mills is served by more than one water system. These systems supply ZIP codes in Owings Mills and were tested for PFAS ("forever chemicals") in EPA's nationwide UCMR 5 study. Check your water bill to see which one is yours.
Water systems serving Owings Mills
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| City of Baltimore serves over 10,000 people | PFPeA | — | Aug 2024 – May 2025 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Owings Mills
Owings Mills is served by more than one water system. Their service line inventories, as reported to EPA:
Water systems serving Owings Mills
| Water system | Service lines | Total |
|---|---|---|
| City of Baltimore | 47 lead · 385 galvanized · 335,694 unknown | 336,126 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Owings Mills drinking water violations
Owings Mills is served by more than one water system. Health-based violations recorded by EPA since 2016:
Water systems serving Owings Mills
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| City of Baltimore | 4 | 7 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Owings Mills
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| RED RUN NEAR BELLTOWN, MD USGS Maryland Water Science Center | Stream | 1.2 mi | 78 mg/L | 1 | 2000 |
| GWYNNS FALLS TRIBUTARY AT MCDONOGH, MD USGS Maryland Water Science Center | Stream | 1.2 mi | 46 mg/L | 1 | 2000 |
| BA Dc 454 USGS Maryland Water Science Center | Well | 3.1 mi | 67 mg/L | 1 | 2000 |
| BA Ec 205 USGS Maryland Water Science Center | Well | 3.3 mi | 237 mg/L | 1 | 2001 |
| BA Dc 455 USGS Maryland Water Science Center | Well | 3.4 mi | 138 mg/L | 1 | 2000 |
| BA Dc 456 USGS Maryland Water Science Center | Well | 3.4 mi | 137 mg/L | 1 | 2000 |
Water hardness in towns near Owings Mills
| Town | Distance | Median | Class |
|---|---|---|---|
| Randallstown | 3 mi | 70 mg/L | Moderately hard |
| Reisterstown | 3 mi | 78 mg/L | Moderately hard |
| Milford Mill | 4 mi | 78 mg/L | Moderately hard |
| Pikesville | 5 mi | 237 mg/L | Very hard |
| Lochearn | 5 mi | 138 mg/L | Hard |
| Mays Chapel | 7 mi | 216 mg/L | Very hard |
| Woodlawn | 8 mi | 103 mg/L | Moderately hard |
| Eldersburg | 9 mi | 61 mg/L | Moderately hard |
| Towson | 9 mi | 244 mg/L | Very hard |
| Ellicott City | 10 mi | 76 mg/L | Moderately hard |
Baltimore County
Owings Mills is in Baltimore County, where the median is 154 mg/L (hard) across 198 sites.
See all of Baltimore County →Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.