Water hardness in Mill Creek, WA
Water in Mill Creek is moderately hard, with a median of 82 mg/L (4.8 grains per gallon) across 4 monitoring sites within 10 miles.
Mill Creek tap water at a glance
- HardnessModerately hard (82 mg/L, 4.8 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 82 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 4.8 gpg (4.6 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Mill Creek
Prefilled with Mill Creek's measured local hardness of 82 mg/L (4.8 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Mill Creek tap water
Mill Creek is served by more than one water system. These systems supply ZIP codes in Mill Creek and were tested for PFAS ("forever chemicals") in EPA's nationwide UCMR 5 study. Check your water bill to see which one is yours.
Water systems serving Mill Creek
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| Cross Valley Water District serves over 10,000 people | PFBS, PFHxA, PFPeA | — | May 2024 – Feb 2025 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Mill Creek
Mill Creek is served by more than one water system. Their service line inventories, as reported to EPA:
Water systems serving Mill Creek
| Water system | Service lines | Total |
|---|---|---|
| Cross Valley Water District | 0 lead · 0 galvanized · 0 unknown | 7,179 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Mill Creek drinking water violations
Mill Creek is served by more than one water system. Health-based violations recorded by EPA since 2016:
Water systems serving Mill Creek
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| Cross Valley Water District | None | 3 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Mill Creek
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| SWAMP CREEK NEAR MOUNTLAKE TERRACE, WA USGS Washington Water Science Center | Stream | 5.5 mi | 88 mg/L | 10 | 2015 |
| French Cr nr Mouth Washington Department Of Ecology | River/Stream | 6.6 mi | 66 mg/L | 6 | 2011–2012 |
| BEAR CREEK AT WOODINVILLE, WA USGS Washington Water Science Center | Stream | 7.8 mi | 75 mg/L | 10 | 2015 |
| 27N/03E-35A01 SU-015 USGS Washington Water Science Center | Well | 9.3 mi | 173 mg/L | 1 | 2016 |
Water hardness in towns near Mill Creek
| Town | Distance | Median | Class |
|---|---|---|---|
| Martha Lake | 2 mi | 88 mg/L | Moderately hard |
| Mill Creek East | 2 mi | 75 mg/L | Moderately hard |
| Eastmont | 3 mi | 70 mg/L | Moderately hard |
| Silver Firs | 3 mi | 70 mg/L | Moderately hard |
| North Lynnwood | 3 mi | 82 mg/L | Moderately hard |
| Bothell West | 4 mi | 91 mg/L | Moderately hard |
| Lynnwood | 5 mi | 98 mg/L | Moderately hard |
| Mukilteo | 5 mi | 31 mg/L | Soft |
| Bothell | 6 mi | 88 mg/L | Moderately hard |
| Mountlake Terrace | 6 mi | 98 mg/L | Moderately hard |
Snohomish County
Mill Creek is in Snohomish County, where the median is 31 mg/L (soft) across 99 sites.
See all of Snohomish County →Washington
The statewide median is 74 mg/L (moderately hard) from 890 sites.
Washington hardness map →Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.