Water hardness in Mountlake Terrace, WA

Water in Mountlake Terrace is moderately hard, with a median of 98 mg/L (5.7 grains per gallon) across 6 monitoring sites within 10 miles.

32% harder than the Washington median (74 mg/L) 16th hardest of 122 Washington towns Population 21,516
98mg/L
5.7 grains per gallon
Moderately hard

Mountlake Terrace tap water at a glance

  • HardnessModerately hard (98 mg/L, 5.7 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
  • PFASNone found in EPA's nationwide testing of the main water system.PFAS results →
  • Lead pipesNo lead service lines reported.Details →
  • ViolationsNo health-based violations since 2016.EPA record →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 98 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 5.7 gpg (5.5 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites6
Lab samples60
Sample years2001–2016
Middle 50% of sites90–113 mg/L
Groundwater (wells, springs)173 mg/L · 1 sites
Surface water (rivers, lakes)93 mg/L · 5 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Mountlake Terrace

Prefilled with Mountlake Terrace's measured local hardness of 98 mg/L (5.7 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Mountlake Terrace tap water

City of Mountlake Terrace is the main public water system for Mountlake Terrace. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken May 2023 – Feb 2024. No PFAS were found at or above EPA's minimum reporting levels.

Other water systems serving parts of Mountlake Terrace

Water systemPFAS detectedHighest PFOA / PFOSTested
City of Edmonds
serves over 10,000 people
None detected — Sep 2023 – Jun 2024
City of Lynnwood
serves over 10,000 people
None detected — May 2023 – Feb 2024
Olympic View Water & Sewer District
serves over 10,000 people
None detected — May 2023 – Feb 2024

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Mountlake Terrace

City of Mountlake Terrace reported 6,322 service lines (the pipes connecting homes to the water main) in its inventory. It reported no lead or galvanized lines requiring replacement.

0lead (0%)
0galvanized requiring replacement
0unknown material (0%)
6,322not lead (100%)

Other water systems serving parts of Mountlake Terrace

Water systemService linesTotal
City of Edmonds0 lead · 0 galvanized · 0 unknown10,459
City of LynnwoodNot reported—
Olympic View Water & Sewer District0 lead · 0 galvanized · 0 unknown5,106

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Mountlake Terrace drinking water violations

EPA records show no health-based violations for City of Mountlake Terrace since 2016. It also had 6 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Other water systems serving parts of Mountlake Terrace

Water systemHealth-based violationsMonitoring/reporting
City of EdmondsNone0
City of LynnwoodNone2
Olympic View Water & Sewer DistrictNone2

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Mountlake Terrace

SiteTypeDistanceMedianSamplesYears
SWAMP CREEK NEAR MOUNTLAKE TERRACE, WA
USGS Washington Water Science Center
Stream 2.2 mi88 mg/L102015
27N/03E-35A01 SU-015
USGS Washington Water Science Center
Well 3.5 mi173 mg/L12016
PIPERS CREEK AT CARKEEK PARK, AT SEATTLE, WA
USGS Washington Water Science Center
Stream 6.6 mi116 mg/L102015
BEAR CREEK AT WOODINVILLE, WA
USGS Washington Water Science Center
Stream 6.9 mi75 mg/L102015
THORNTON CREEK NEAR SEATTLE, WA
USGS Washington Water Science Center
Stream 6.9 mi103 mg/L192001–2015
JUANITA CREEK NEAR KIRKLAND, WA
USGS Washington Water Science Center
Stream 7.3 mi93 mg/L102015

Water hardness in towns near Mountlake Terrace

TownDistanceMedianClass
Lynnwood2 mi 98 mg/LModerately hard
Lake Forest Park2 mi 93 mg/LModerately hard
Edmonds3 mi 98 mg/LModerately hard
Bothell West3 mi 91 mg/LModerately hard
Shoreline3 mi 98 mg/LModerately hard
Kenmore4 mi 91 mg/LModerately hard
North Lynnwood4 mi 82 mg/LModerately hard
Martha Lake5 mi 88 mg/LModerately hard
Bothell5 mi 88 mg/LModerately hard
Mill Creek East6 mi 75 mg/LModerately hard

Snohomish County

Mountlake Terrace is in Snohomish County, where the median is 31 mg/L (soft) across 99 sites.

See all of Snohomish County →

Washington

The statewide median is 74 mg/L (moderately hard) from 890 sites.

Washington hardness map →

Mountlake Terrace, WA water: common questions

Do I need a water softener in Mountlake Terrace?

Probably not. Water measured around Mountlake Terrace is 5.7 gpg (98 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable. If spotting bothers you, about 10,000 grains of capacity covers a 3-person home between weekly regenerations.Size it for your household →

Who supplies Mountlake Terrace's drinking water?

The main public water system serving Mountlake Terrace in EPA records is City of Mountlake Terrace. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Mountlake Terrace?

Not for anything in EPA's records: no PFAS found in EPA testing, no lead service lines reported and no health-based violations since 2016. People here who use a filter usually do it for taste, such as chlorine.Chlorine taste in tap water →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next