Water hardness in Martha Lake, WA

Water in Martha Lake is moderately hard, with a median of 88 mg/L (5.2 grains per gallon) across 5 monitoring sites within 10 miles.

19% harder than the Washington median (74 mg/L) 25th hardest of 122 Washington towns Population 15,473 (2010)
88mg/L
5.2 grains per gallon
Moderately hard

Martha Lake tap water at a glance

  • HardnessModerately hard (88 mg/L, 5.2 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 88 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 5.2 gpg (4.9 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites5
Lab samples37
Sample years2011–2016
Middle 50% of sites75–93 mg/L
Groundwater (wells, springs)173 mg/L · 1 sites
Surface water (rivers, lakes)82 mg/L · 4 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Martha Lake

Prefilled with Martha Lake's measured local hardness of 88 mg/L (5.1 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Martha Lake tap water

Martha Lake is served by more than one water system. These systems supply ZIP codes in Martha Lake and were tested for PFAS ("forever chemicals") in EPA's nationwide UCMR 5 study. Check your water bill to see which one is yours.

Water systems serving Martha Lake

Water systemPFAS detectedHighest PFOA / PFOSTested
City of Lynnwood
serves over 10,000 people
None detected — May 2023 – Feb 2024
Alderwood Water District
serves over 10,000 people
None detected — Feb 2023 – Nov 2023
Cross Valley Water District
serves over 10,000 people
PFBS, PFHxA, PFPeA — May 2024 – Feb 2025
City of Everett Public Works Dept.
serves over 10,000 people
None detected — Feb 2023 – Nov 2023
Mukilteo Water & Wastewater Distr
serves over 10,000 people
None detected — Feb 2023 – Nov 2023

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Martha Lake

Martha Lake is served by more than one water system. Their service line inventories, as reported to EPA:

Water systems serving Martha Lake

Water systemService linesTotal
City of LynnwoodNot reported—
Alderwood Water District0 lead · 0 galvanized · 24,002 unknown58,623
Cross Valley Water District0 lead · 0 galvanized · 0 unknown7,179
City of Everett Public Works Dept.0 lead · 0 galvanized · 0 unknown29,738
Mukilteo Water & Wastewater Distr0 lead · 0 galvanized · 0 unknown5,827

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Martha Lake drinking water violations

Martha Lake is served by more than one water system. Health-based violations recorded by EPA since 2016:

Water systems serving Martha Lake

Water systemHealth-based violationsMonitoring/reporting
City of LynnwoodNone2
Alderwood Water DistrictNone0
Cross Valley Water DistrictNone3
City of Everett Public Works Dept.None2
Mukilteo Water & Wastewater DistrNone1

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Martha Lake

SiteTypeDistanceMedianSamplesYears
SWAMP CREEK NEAR MOUNTLAKE TERRACE, WA
USGS Washington Water Science Center
Stream 3.8 mi88 mg/L102015
BEAR CREEK AT WOODINVILLE, WA
USGS Washington Water Science Center
Stream 6.8 mi75 mg/L102015
27N/03E-35A01 SU-015
USGS Washington Water Science Center
Well 7.7 mi173 mg/L12016
French Cr nr Mouth
Washington Department Of Ecology
River/Stream 8.1 mi66 mg/L62011–2012
JUANITA CREEK NEAR KIRKLAND, WA
USGS Washington Water Science Center
Stream 9.5 mi93 mg/L102015

Water hardness in towns near Martha Lake

TownDistanceMedianClass
Mill Creek2 mi 82 mg/LModerately hard
North Lynnwood2 mi 82 mg/LModerately hard
Mill Creek East2 mi 75 mg/LModerately hard
Bothell West3 mi 91 mg/LModerately hard
Lynnwood3 mi 98 mg/LModerately hard
Silver Firs4 mi 70 mg/LModerately hard
Eastmont4 mi 70 mg/LModerately hard
Mountlake Terrace5 mi 98 mg/LModerately hard
Bothell5 mi 88 mg/LModerately hard
Mukilteo6 mi 31 mg/LSoft

Snohomish County

Martha Lake is in Snohomish County, where the median is 31 mg/L (soft) across 99 sites.

See all of Snohomish County →

Washington

The statewide median is 74 mg/L (moderately hard) from 890 sites.

Washington hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next