Water hardness in Anacortes, WA
Water in Anacortes is soft, with a median of 9 mg/L (0.5 grains per gallon) across Skagit County.
There are not enough monitoring sites within 10 miles of Anacortes, so this page uses the Skagit County median.
Anacortes tap water at a glance
- HardnessSoft (9 mg/L, 0.5 gpg, local measurements). A water softener isn't needed.Water heater care →
- PFASNone found in EPA's nationwide testing of the main water system.PFAS results →
- Lead pipesNo known lead lines; 7,858 lines are still of unknown material.Check your own pipe →
- ViolationsNo health-based violations since 2016.EPA record →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 9 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 0.5 gpg (0.5 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Anacortes
Prefilled with Anacortes's measured local hardness of 9 mg/L (0.5 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Anacortes tap water
City of Anacortes is the main public water system for Anacortes. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Mar 2023 – Dec 2023. No PFAS were found at or above EPA's minimum reporting levels.
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Anacortes
City of Anacortes reported 18,574 service lines (the pipes connecting homes to the water main) in its inventory. 0 are lead and 32 are galvanized lines that must be replaced, and 7,858 are still of unknown material.
EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask City of Anacortes whether your address is on its list.
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Anacortes drinking water violations
EPA records show no health-based violations for City of Anacortes since 2016.
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Water hardness in towns near Anacortes
| Town | Distance | Median | Class |
|---|---|---|---|
| Oak Harbor | 13 mi | 289 mg/L | Very hard |
| Burlington | 14 mi | 9 mg/L | Soft |
| Mount Vernon | 15 mi | 9 mg/L | Soft |
| Sedro-Woolley | 18 mi | 9 mg/L | Soft |
| Bellingham | 20 mi | 120 mg/L | Hard |
| Ferndale | 25 mi | 132 mg/L | Hard |
| Port Townsend | 26 mi | 25 mg/L | Soft |
| Arlington | 31 mi | 36 mg/L | Soft |
| Lynden | 33 mi | 134 mg/L | Hard |
| Marysville | 36 mi | 29 mg/L | Soft |
Skagit County
Anacortes is in Skagit County, where the median is 9 mg/L (soft) across 8 sites.
See all of Skagit County →Washington
The statewide median is 74 mg/L (moderately hard) from 890 sites.
Washington hardness map →Anacortes, WA water: common questions
Do I need a water softener in Anacortes?
Probably not. Water measured around Anacortes is 0.5 gpg (9 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable.When a softener helps →
Who supplies Anacortes's drinking water?
The main public water system serving Anacortes in EPA records is City of Anacortes. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →
Do I need a water filter in Anacortes?
Not for anything in EPA's records: no PFAS found in EPA testing, no lead service lines reported and no health-based violations since 2016. People here who use a filter usually do it for taste, such as chlorine.Chlorine taste in tap water →
Hardness scale
What to read next
- How to tell if your home has a lead pipe7,858 service lines here are of unknown material.
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.