Water hardness in Cleburne, TX

Water in Cleburne is very hard, with a median of 280 mg/L (16.4 grains per gallon) across Johnson County.

44% harder than the Texas median (194 mg/L) 54th hardest of 251 Texas towns Population 36,209
280mg/L
16.4 grains per gallon
Very hard

There are not enough monitoring sites within 10 miles of Cleburne, so this page uses the Johnson County median.

Cleburne tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 280 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 16.4 gpg (15.7 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites3
Lab samples22
Sample years2003–2016
Middle 50% of sites145–285 mg/L
Groundwater (wells, springs)9 mg/L · 1 sites
Surface water (rivers, lakes)285 mg/L · 2 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Cleburne

Prefilled with Cleburne's measured local hardness of 280 mg/L (16.4 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Cleburne tap water

City of Cleburne is the main public water system for Cleburne. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Jun 2023 – Apr 2024. 1 PFAS was detected.

ChemicalHighest resultDetected inEPA limit
PFBA
perfluorobutanoic acid
7.6 ppt 3 of 4 samples —

Other water systems serving parts of Cleburne

Water systemPFAS detectedHighest PFOA / PFOSTested
Johnson County Sud
serves over 10,000 people
PFBA, PFPeA, PFHxA +1 more — Jan 2024 – Feb 2025
Bethesda WSC
serves over 10,000 people
PFBA — Feb 2025 – Nov 2025

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Cleburne

City of Cleburne reported 14,165 service lines (the pipes connecting homes to the water main) in its inventory. 0 are lead and 1 are galvanized lines that must be replaced, and 10,375 are still of unknown material.

0lead (0%)
1galvanized requiring replacement
10,375unknown material (73%)
3,789not lead (27%)

EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask City of Cleburne whether your address is on its list.

Other water systems serving parts of Cleburne

Water systemService linesTotal
Johnson County Sud0 lead · 0 galvanized · 0 unknown20,889
Bethesda WSC0 lead · 241 galvanized · 32 unknown11,283

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Cleburne drinking water violations

EPA records show no health-based violations for City of Cleburne since 2016. It also had 4 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Other water systems serving parts of Cleburne

Water systemHealth-based violationsMonitoring/reporting
Johnson County SudNone15
Bethesda WSCNone14

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Cleburne

SiteTypeDistanceMedianSamplesYears
BT-32-46-404
USGS Texas Water Science Center
Well 5.6 mi9 mg/L12016

Water hardness in towns near Cleburne

TownDistanceMedianClass
Burleson12 mi 130 mg/LHard
Crowley16 mi 125 mg/LHard
Rendon19 mi 110 mg/LModerately hard
Mansfield23 mi 163 mg/LHard
Benbrook23 mi 370 mg/LVery hard
Forest Hill23 mi 120 mg/LModerately hard
Kennedale23 mi 154 mg/LHard
Midlothian26 mi 166 mg/LHard
White Settlement28 mi 370 mg/LVery hard
Arlington29 mi 160 mg/LHard

Johnson County

Cleburne is in Johnson County, where the median is 280 mg/L (very hard) across 3 sites.

See all of Johnson County →

Texas

The statewide median is 194 mg/L (very hard) from 2,271 sites.

Texas hardness map →

Cleburne, TX water: common questions

Do I need a water softener in Cleburne?

Very likely. Water measured around Cleburne is 16.4 gpg (280 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 29,000 grains.Size it for your household →

Who supplies Cleburne's drinking water?

The main public water system serving Cleburne in EPA records is City of Cleburne. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Cleburne?

It depends on what you want to remove. In Cleburne, EPA testing found PFBA in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS. On the other hand, no lead service lines reported and no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next