Water hardness in Franklin Park, IL

Water in Franklin Park is very hard, with a median of 276 mg/L (16.1 grains per gallon) across 16 monitoring sites within 10 miles.

about the same as the Illinois median (293 mg/L) 131st hardest of 225 Illinois towns Population 17,871
276mg/L
16.1 grains per gallon
Very hard

Franklin Park tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 276 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 16.1 gpg (15.5 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites16
Lab samples204
Sample years2000–2017
Middle 50% of sites231–290 mg/L
Groundwater (wells, springs)157 mg/L · 1 sites
Surface water (rivers, lakes)277 mg/L · 15 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Franklin Park

Prefilled with Franklin Park's measured local hardness of 276 mg/L (16.1 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Franklin Park tap water

The City of Franklin Park water system is the main public water system for Franklin Park. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Jul 2023 – Apr 2024. No PFAS were found at or above EPA's minimum reporting levels.

Other water systems serving parts of Franklin Park

Water systemPFAS detectedHighest PFOA / PFOSTested
Leyden TWSP Water District
serves over 10,000 people
None detected — Mar 2024 – Dec 2024
Melrose Park
serves over 10,000 people
None detected — Sep 2023 – Jun 2024
Northlake
serves over 10,000 people
None detected — Mar 2024 – Dec 2024

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Franklin Park

The City of Franklin Park water system reported 5,986 service lines (the pipes connecting homes to the water main) in its inventory. 1,964 are lead and 0 are galvanized lines that must be replaced, and 1,927 are still of unknown material.

1,964lead (33%)
0galvanized requiring replacement
1,927unknown material (32%)
2,095not lead (35%)

EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask the City of Franklin Park water system whether your address is on its list.

Other water systems serving parts of Franklin Park

Water systemService linesTotal
Leyden TWSP Water District110 lead · 93 galvanized · 3 unknown2,993
Melrose Park744 lead · 0 galvanized · 2,326 unknown5,056
Northlake150 lead · 87 galvanized · 1,447 unknown3,093

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Franklin Park drinking water violations

EPA records show no health-based violations for the City of Franklin Park water system since 2016. It also had 5 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Other water systems serving parts of Franklin Park

Water systemHealth-based violationsMonitoring/reporting
Leyden TWSP Water DistrictNone5
Melrose ParkNone1
NorthlakeNone3

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Franklin Park

SiteTypeDistanceMedianSamplesYears
Des Plaines River
illinois epa (State)
River/Stream 1.7 mi286 mg/L242000–2002
ADDISON CREEK AT BELLWOOD, IL
USGS Illinois Water Science Center
Stream 3.8 mi237 mg/L12000
Addison Creek
illinois epa (State)
River/Stream 3.8 mi306 mg/L242000–2002
WILLOW CREEK AT DES PLAINES R RD NR ROSEMONT, IL
USGS Illinois Water Science Center
Stream 3.9 mi270 mg/L12000
ADDISON CREEK AT 19TH AVENUE AT BROADVIEW, IL
USGS Illinois Water Science Center
Stream 6.1 mi298 mg/L12004
North Branch Chicago River
illinois epa (State)
River/Stream 6.8 mi280 mg/L242000–2002

Water hardness in towns near Franklin Park

TownDistanceMedianClass
Schiller Park2 mi 275 mg/LVery hard
Northlake2 mi 279 mg/LVery hard
River Grove2 mi 276 mg/LVery hard
Melrose Park2 mi 277 mg/LVery hard
Elmwood Park3 mi 280 mg/LVery hard
Norridge3 mi 270 mg/LVery hard
Bensenville4 mi 283 mg/LVery hard
Bellwood4 mi 279 mg/LVery hard
River Forest4 mi 286 mg/LVery hard
Elmhurst4 mi 282 mg/LVery hard

Cook County

Franklin Park is in Cook County, where the median is 252 mg/L (very hard) across 63 sites.

See all of Cook County →

Illinois

The statewide median is 293 mg/L (very hard) from 1,100 sites.

Illinois hardness map →

Franklin Park, IL water: common questions

Do I need a water softener in Franklin Park?

Very likely. Water measured around Franklin Park is 16.1 gpg (276 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 28,000 grains.Size it for your household →

Who supplies Franklin Park's drinking water?

The main public water system serving Franklin Park in EPA records is Franklin Park. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Franklin Park?

It depends on what you want to remove. In Franklin Park, the system reports 1,964 lead service lines; if your home has one, a filter certified to remove lead is the usual step until the line is replaced. On the other hand, no PFAS found in EPA testing and no health-based violations since 2016. A water softener is not a filter.Check your own service line →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next