Water hardness in Redmond, WA

Water in Redmond is moderately hard, with a median of 73 mg/L (4.3 grains per gallon) across 10 monitoring sites within 10 miles.

about the same as the Washington median (74 mg/L) 39th hardest of 122 Washington towns Population 80,280
73mg/L
4.3 grains per gallon
Moderately hard

Redmond tap water at a glance

  • HardnessModerately hard (73 mg/L, 4.3 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
  • PFAS2 found; the highest PFOS result was above EPA's 4 ppt limit (a single result is not a violation).Filters that remove PFAS →
  • Lead pipesNo lead service lines reported.Details →
  • ViolationsNo health-based violations since 2016.EPA record →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 73 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 4.3 gpg (4.1 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites10
Lab samples94
Sample years2001–2016
Middle 50% of sites66–100 mg/L
Groundwater (wells, springs)54 mg/L · 1 sites
Surface water (rivers, lakes)75 mg/L · 9 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Redmond

Prefilled with Redmond's measured local hardness of 73 mg/L (4.3 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Redmond tap water

City of Redmond Water System is the main public water system for Redmond. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 10 samples taken Nov 2023 – Aug 2024. 2 PFAS were detected. The highest PFOS result was above EPA's drinking water limit (4 ppt).

ChemicalHighest resultDetected inEPA limit
PFOS
perfluorooctane sulfonic acid
5 ppt 1 of 10 samples 4 ppt
PFBS
perfluorobutane sulfonic acid
5 ppt 2 of 10 samples —

Other water systems serving parts of Redmond

Water systemPFAS detectedHighest PFOA / PFOSTested
Woodinville Water District
serves over 10,000 people
None detected — Sep 2024 – Jun 2025
City of Kirkland
serves over 10,000 people
None detected — Sep 2024 – Jun 2025
City of Bellevue
serves over 10,000 people
None detected — Jan 2024 – Oct 2024
Sammamish Plateau Water & Sewer
serves over 10,000 people
PFHxS, PFOS, PFBS +3 more ND / 11.1 ppt May 2023 – Feb 2024

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Redmond

City of Redmond Water System reported 18,652 service lines (the pipes connecting homes to the water main) in its inventory. It reported no lead or galvanized lines requiring replacement.

0lead (0%)
0galvanized requiring replacement
0unknown material (0%)
18,652not lead (100%)

Other water systems serving parts of Redmond

Water systemService linesTotal
Woodinville Water District0 lead · 0 galvanized · 0 unknown14,831
City of Kirkland0 lead · 82 galvanized · 0 unknown13,332
City of Bellevue0 lead · 0 galvanized · 9,739 unknown40,476
Sammamish Plateau Water & Sewer0 lead · 0 galvanized · 17,213 unknown36,913

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Redmond drinking water violations

EPA records show no health-based violations for City of Redmond Water System since 2016.

Other water systems serving parts of Redmond

Water systemHealth-based violationsMonitoring/reporting
Woodinville Water DistrictNone0
City of KirklandNone0
City of BellevueNone0
Sammamish Plateau Water & SewerNone0

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Redmond

SiteTypeDistanceMedianSamplesYears
BEAR CREEK AT UNION HILL RD AT REDMOND, WA
USGS Washington Water Science Center
Stream 0.4 mi65 mg/L102015
COTTAGE LAKE CREEK AB BEAR CREEK NEAR REDMOND, WA
USGS Washington Water Science Center
Stream 3 mi70 mg/L102015
JUANITA CREEK NEAR KIRKLAND, WA
USGS Washington Water Science Center
Stream 5.1 mi93 mg/L102015
BEAR CREEK AT WOODINVILLE, WA
USGS Washington Water Science Center
Stream 5.9 mi75 mg/L102015
MERCER CREEK NEAR BELLEVUE, WA
USGS Washington Water Science Center
Stream 6 mi110 mg/L102015
THORNTON CREEK NEAR SEATTLE, WA
USGS Washington Water Science Center
Stream 7.6 mi103 mg/L192001–2015

Water hardness in towns near Redmond

TownDistanceMedianClass
Union Hill-Novelty Hill4 mi 70 mg/LModerately hard
Kirkland4 mi 93 mg/LModerately hard
Cottage Lake5 mi 66 mg/LModerately hard
Woodinville6 mi 70 mg/LModerately hard
Bellevue6 mi 71 mg/LModerately hard
Sammamish7 mi 70 mg/LModerately hard
Bothell8 mi 88 mg/LModerately hard
Kenmore8 mi 91 mg/LModerately hard
Maltby9 mi 68 mg/LModerately hard
Mercer Island10 mi 80 mg/LModerately hard

King County

Redmond is in King County, where the median is 61 mg/L (moderately hard) across 34 sites.

See all of King County →

Washington

The statewide median is 74 mg/L (moderately hard) from 890 sites.

Washington hardness map →

Redmond, WA water: common questions

Do I need a water softener in Redmond?

Probably not. Water measured around Redmond is 4.3 gpg (73 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable. If spotting bothers you, about 8,000 grains of capacity covers a 3-person home between weekly regenerations.Size it for your household →

Who supplies Redmond's drinking water?

The main public water system serving Redmond in EPA records is City of Redmond Water System. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Redmond?

It depends on what you want to remove. In Redmond, EPA testing found PFOS and PFBS in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS. On the other hand, no lead service lines reported and no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next