Water hardness in Artondale, WA
Water in Artondale is soft, with a median of 45 mg/L (2.6 grains per gallon) across 5 monitoring sites within 10 miles.
Artondale tap water at a glance
- HardnessSoft (45 mg/L, 2.6 gpg, local measurements). A water softener isn't needed.Water heater care →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 45 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 2.6 gpg (2.5 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Artondale
Prefilled with Artondale's measured local hardness of 45 mg/L (2.6 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Artondale tap water
Artondale is served by more than one water system. These systems supply ZIP codes in Artondale and were tested for PFAS ("forever chemicals") in EPA's nationwide UCMR 5 study. Check your water bill to see which one is yours.
Water systems serving Artondale
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| Gig Harbor Water Dept serves over 10,000 people | None detected | — | Jun 2024 – Dec 2024 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Artondale
Artondale is served by more than one water system. Their service line inventories, as reported to EPA:
Water systems serving Artondale
| Water system | Service lines | Total |
|---|---|---|
| Gig Harbor Water Dept | 0 lead · 43 galvanized · 0 unknown | 3,673 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Artondale drinking water violations
Artondale is served by more than one water system. Health-based violations recorded by EPA since 2016:
Water systems serving Artondale
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| Gig Harbor Water Dept | None | 0 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Artondale
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| CRESCENT CR AT CRESCENT VAL DR NR GIG HARBOR, WA USGS Washington Water Science Center | Stream | 5.1 mi | 64 mg/L | 10 | 2015 |
| MINTER CREEK ABOVE HUGE CREEK NEAR WAUNA, WA USGS Washington Water Science Center | Stream | 6.3 mi | 44 mg/L | 10 | 2015 |
| HUGE CREEK NEAR WAUNA, WA USGS Washington Water Science Center | Stream | 6.3 mi | 37 mg/L | 10 | 2015 |
| 20N/02E-28L01 UR-36 USGS Washington Water Science Center | Well | 8.7 mi | 111 mg/L | 1 | 2005 |
| OLALLA CREEK AT BURLEY OLALLA ROAD NEAR OLALLA, WA USGS Washington Water Science Center | Stream | 9.5 mi | 45 mg/L | 10 | 2015 |
Water hardness in towns near Artondale
| Town | Distance | Median | Class |
|---|---|---|---|
| Gig Harbor | 3 mi | 45 mg/L | Soft |
| University Place | 8 mi | 51 mg/L | Soft |
| Tacoma | 10 mi | 63 mg/L | Moderately hard |
| Lakewood | 11 mi | 51 mg/L | Soft |
| Vashon | 12 mi | 64 mg/L | Moderately hard |
| Federal Way | 15 mi | 80 mg/L | Moderately hard |
| Fort Lewis | 15 mi | 51 mg/L | Soft |
| Fife | 15 mi | 70 mg/L | Moderately hard |
| Parkland | 15 mi | 52 mg/L | Soft |
| Port Orchard | 16 mi | 70 mg/L | Moderately hard |
Pierce County
Artondale is in Pierce County, where the median is 51 mg/L (soft) across 73 sites.
See all of Pierce County →Washington
The statewide median is 74 mg/L (moderately hard) from 890 sites.
Washington hardness map →Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.