Water hardness in Lumberton, NC
Water in Lumberton is soft, with a median of 16 mg/L (0.9 grains per gallon) across 6 monitoring sites within 10 miles.
Lumberton tap water at a glance
- HardnessSoft (16 mg/L, 0.9 gpg, local measurements). A water softener isn't needed.Water heater care →
- PFAS4 found; the highest PFOS and PFOA result was above EPA's 4 ppt limit (a single result is not a violation).Filters that remove PFAS →
- Lead pipesNo known lead lines; 7,708 lines are still of unknown material.Check your own pipe →
- Violations1 health-based violation since 2016.What they were →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 16 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 0.9 gpg (0.9 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Lumberton
Prefilled with Lumberton's measured local hardness of 16 mg/L (0.9 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Lumberton tap water
City of Lumberton is the main public water system for Lumberton. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Oct 2024 – Jul 2025. 4 PFAS were detected. The highest PFOS and PFOA results were above EPA's drinking water limit (4 ppt).
| Chemical | Highest result | Detected in | EPA limit |
|---|---|---|---|
| PFOS perfluorooctane sulfonic acid | 7.9 ppt | 3 of 4 samples | 4 ppt |
| PFOA perfluorooctanoic acid | 5.7 ppt | 4 of 4 samples | 4 ppt |
| PFPeA perfluoropentanoic acid | 4.4 ppt | 2 of 4 samples | — |
| PFHxA perfluorohexanoic acid | 3.3 ppt | 1 of 4 samples | — |
Other water systems serving parts of Lumberton
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| Robeson County Water System serves over 10,000 people | HFPO-DA, PFOA, PFPeA +7 more | 30 / 6.1 ppt | Feb 2023 – Jul 2023 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Lumberton
City of Lumberton reported 8,618 service lines (the pipes connecting homes to the water main) in its inventory. It reported no known lead lines, but 7,708 lines are still of unknown material.
Other water systems serving parts of Lumberton
| Water system | Service lines | Total |
|---|---|---|
| Robeson County Water System | 0 lead · 0 galvanized · 20,926 unknown | 27,161 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Lumberton drinking water violations
EPA records show 1 health-based violation for City of Lumberton since 2016, all since resolved or closed. The most recent began in Oct 2024. It also had 1 monitoring or reporting violation (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.
| Contaminant or rule | Type | Violations | Most recent | Status |
|---|---|---|---|---|
| Lead and Copper Rule Revisions lead service line inventory and lead rule requirements | Treatment requirement not met | 1 | Oct 2024 | Resolved/closed |
Other water systems serving parts of Lumberton
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| Robeson County Water System | 1 | 0 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Lumberton
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| RAFT SWAMP AT SR 1527 NR MOSS NECK NCDENR-DWQ (2nd) | River/Stream | 3.4 mi | 18 mg/L | 12 | 2000–2001 |
| LUMBER RIV AT SR 1003 NR PEMBROKE NCDENR-DWQ (2nd) | River/Stream | 9.3 mi | 14 mg/L | 8 | 2000 |
| LUMBER RIV AT SR 2121 NR KINGSDALE NCDENR-DWQ (2nd) | River/Stream | 9.7 mi | 15 mg/L | 12 | 2000–2001 |
| LUMBER RIV AT SR 2121 NR KINGSDALE North Carolina Dept of Environmental Quality NCDEQ-DWR WQX | River/Stream | 9.7 mi | 15 mg/L | 20 | 2010–2025 |
| BIG SWAMP AT NC 211 NR RICHARDSON NCDENR-DWQ (2nd) | River/Stream | 9.9 mi | 21 mg/L | 12 | 2000–2001 |
| BIG SWAMP AT NC 211 NR RICHARDSON North Carolina Dept of Environmental Quality NCDEQ-DWR WQX | River/Stream | 9.9 mi | 17 mg/L | 20 | 2010–2025 |
Water hardness in towns near Lumberton
| Town | Distance | Median | Class |
|---|---|---|---|
| Hope Mills | 24 mi | 11 mg/L | Soft |
| Laurinburg | 28 mi | 22 mg/L | Soft |
| Fayetteville | 31 mi | 11 mg/L | Soft |
| Spring Lake | 38 mi | 8 mg/L | Soft |
| Southern Pines | 44 mi | 8 mg/L | Soft |
| Pinehurst | 46 mi | 7 mg/L | Soft |
| Sanford | 60 mi | 90 mg/L | Moderately hard |
| Leland | 62 mi | 41 mg/L | Soft |
| Fuquay-Varina | 68 mi | 24 mg/L | Soft |
| Wilmington | 71 mi | 230 mg/L | Very hard |
Robeson County
Lumberton is in Robeson County, where the median is 18 mg/L (soft) across 17 sites.
See all of Robeson County →North Carolina
The statewide median is 33 mg/L (soft) from 1,749 sites.
North Carolina hardness map →Lumberton, NC water: common questions
Do I need a water softener in Lumberton?
Probably not. Water measured around Lumberton is 0.9 gpg (16 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable.When a softener helps →
Who supplies Lumberton's drinking water?
The main public water system serving Lumberton in EPA records is City of Lumberton. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →
Do I need a water filter in Lumberton?
It depends on what you want to remove. In Lumberton, EPA testing found PFOS, PFOA and PFPeA and 1 other PFAS in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS; the system had 1 health-based violation since 2016, for the Lead and Copper Rule Revisions; the utility's annual report says what was done about it. On the other hand, no lead service lines reported. A water softener is not a filter.Filters that remove PFAS →
Hardness scale
What to read next
- Which water filters remove PFAS?EPA tests found 4 PFAS in Lumberton's main water system.
- How to tell if your home has a lead pipe7,708 service lines here are of unknown material.
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.