Water hardness in Port Washington, NY

Water in Port Washington is soft, with a median of 52 mg/L (3 grains per gallon) across 28 monitoring sites within 10 miles.

32% softer than the New York median (77 mg/L) 90th hardest of 193 New York towns Population 15,846 (2010)
52mg/L
3 grains per gallon
Soft

Port Washington tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 52 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 3 gpg (2.9 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites28
Lab samples62
Sample years2006–2022
Middle 50% of sites32–93 mg/L
Groundwater (wells, springs)48 mg/L · 26 sites
Surface water (rivers, lakes)186 mg/L · 2 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Port Washington

Prefilled with Port Washington's measured local hardness of 52 mg/L (3 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Port Washington tap water

Port Washington WD is the main public water system for Port Washington. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 18 samples taken Feb 2023 – Jun 2026. 6 PFAS were detected. The highest PFOA and PFOS results were above EPA's drinking water limit (4 ppt).

ChemicalHighest resultDetected inEPA limit
PFPeA
perfluoropentanoic acid
6.9 ppt 3 of 18 samples —
6:2 FTS
6:2 fluorotelomer sulfonic acid
6.5 ppt 1 of 18 samples —
PFOA
perfluorooctanoic acid
5.3 ppt 3 of 18 samples 4 ppt
PFOS
perfluorooctane sulfonic acid
4.7 ppt 1 of 18 samples 4 ppt
PFNA
perfluorononanoic acid
4.2 ppt 1 of 18 samples 10 ppt*
PFHxA
perfluorohexanoic acid
3.6 ppt 2 of 18 samples —

Other water systems serving parts of Port Washington

Water systemPFAS detectedHighest PFOA / PFOSTested
Manhasset Lakeville WD
serves over 10,000 people
PFNA, PFPeA, PFOA +2 more 5.3 / ND ppt Feb 2025 – Aug 2025

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Port Washington

Port Washington WD reported 9,440 service lines (the pipes connecting homes to the water main) in its inventory. 95 are lead and 0 are galvanized lines that must be replaced, and 2,207 are still of unknown material.

95lead (1%)
0galvanized requiring replacement
2,207unknown material (23%)
7,138not lead (76%)

EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask Port Washington WD whether your address is on its list.

Other water systems serving parts of Port Washington

Water systemService linesTotal
Manhasset Lakeville WD10 lead · 41 galvanized · 320 unknown10,805

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Port Washington drinking water violations

EPA records show no health-based violations for Port Washington WD since 2016.

Other water systems serving parts of Port Washington

Water systemHealth-based violationsMonitoring/reporting
Manhasset Lakeville WDNone0

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Port Washington

SiteTypeDistanceMedianSamplesYears
N 9902. 1
USGS New York Water Science Center
Well 1.7 mi119 mg/L12018
N 14329. 1
USGS New York Water Science Center
Well 3.4 mi81 mg/L12017
N 14330. 1
USGS New York Water Science Center
Well 3.4 mi85 mg/L12017
N 7873. 1
USGS New York Water Science Center
Well 4.1 mi26 mg/L12016
N 5762. 2
USGS New York Water Science Center
Well 4.5 mi69 mg/L12016
N 1651. 1
USGS New York Water Science Center
Well 5 mi42 mg/L12013

Water hardness in towns near Port Washington

TownDistanceMedianClass
Great Neck3 mi 63 mg/LModerately hard
Glen Cove4 mi 54 mg/LSoft
North New Hyde Park6 mi 50 mg/LSoft
Mineola6 mi 44 mg/LSoft
New Hyde Park7 mi 51 mg/LSoft
Westbury7 mi 50 mg/LSoft
Garden City7 mi 38 mg/LSoft
Floral Park7 mi 44 mg/LSoft
New Cassel8 mi 47 mg/LSoft
Jericho8 mi 46 mg/LSoft

Nassau County

Port Washington is in Nassau County, where the median is 50 mg/L (soft) across 47 sites.

See all of Nassau County →

New York

The statewide median is 77 mg/L (moderately hard) from 2,847 sites.

New York hardness map →

Port Washington, NY water: common questions

Do I need a water softener in Port Washington?

Probably not. Water measured around Port Washington is 3 gpg (52 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable.When a softener helps →

Who supplies Port Washington's drinking water?

The main public water system serving Port Washington in EPA records is Port Washington WD. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Port Washington?

It depends on what you want to remove. In Port Washington, EPA testing found PFPeA, 6:2 FTS and PFOA and 3 other PFAS in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS; the system reports 95 lead service lines; if your home has one, a filter certified to remove lead is the usual step until the line is replaced. On the other hand, no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next