Water hardness in Franklin County, NY
Water in Franklin County is soft, with a median of 32 mg/L (1.9 grains per gallon) across 45 monitoring sites.
Franklin County water at a glance
- HardnessSoft (32 mg/L, 1.9 gpg, local measurements). A water softener isn't needed.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 32 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 1.9 gpg (1.8 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Franklin County
Prefilled with Franklin County's measured local hardness of 32 mg/L (1.9 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Franklin County on the New York map
Cities and communities in Franklin County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Malone | 143 | Hard | 5 sites within 10 miles |
| Saranac Lake | 32 | Soft | 14 sites within 10 miles |
| Tupper Lake | 17 | Soft | 16 sites within 10 miles |
| Chateaugay | 140 | Hard | 8 sites within 10 miles |
| Paul Smiths (CDP) | 46 | Soft | 7 sites within 10 miles |
| St. Regis Falls (CDP) | 52 | Soft | 4 sites within 10 miles |
| Brushton | 80 | Moderately hard | 5 sites within 10 miles |
| Burke | 121 | Hard | 7 sites within 10 miles |
| Akwesasne (CDP) | 74 | Moderately hard | 16 sites within 10 miles |
| Fort Covington (CDP) | 101 | Moderately hard | 6 sites within 10 miles |
Water quality in Franklin County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| St. Regis Falls | ST Regis Falls WD | Not tested | 0 lead · 173 unknown | None |
| Fort Covington | Fort Covington WD | Not tested | 1 lead · 156 unknown | None |
Neighboring counties
- Clinton County79 mg/L
- St. Lawrence County29 mg/L
- Essex County17 mg/L
- Hamilton County6 mg/L
- Herkimer County7 mg/L
- Warren County30 mg/L
New York
The statewide median is 77 mg/L (moderately hard) from 2,847 sites.
New York hardness map →Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.