Water hardness in Reading, MA

Water in Reading is moderately hard, with a median of 90 mg/L (5.2 grains per gallon) across 16 monitoring sites within 10 miles.

70% harder than the Massachusetts median (53 mg/L) 16th hardest of 88 Massachusetts towns Population 24,747 (2010)
90mg/L
5.2 grains per gallon
Moderately hard

Reading tap water at a glance

  • HardnessModerately hard (90 mg/L, 5.2 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
  • PFASNone found in EPA's nationwide testing of the main water system.PFAS results →
  • Violations1 health-based violation since 2016.What they were →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 90 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 5.2 gpg (5 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites16
Lab samples229
Sample years2000–2024
Middle 50% of sites75–101 mg/L
Groundwater (wells, springs)103 mg/L · 7 sites
Surface water (rivers, lakes)87 mg/L · 9 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Reading

Prefilled with Reading's measured local hardness of 90 mg/L (5.3 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Reading tap water

Reading Water Department is the main public water system for Reading. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Jan 2024 – Oct 2024. No PFAS were found at or above EPA's minimum reporting levels.

Other water systems serving parts of Reading

Water systemPFAS detectedHighest PFOA / PFOSTested
Winchester Water Dept
serves over 10,000 people
None detected — Apr 2024 – Jan 2025
Woburn Water Dept.
serves over 10,000 people
PFOA, PFBA, PFOS +3 more 8.4 / 6.9 ppt Jan 2025 – Oct 2025

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Reading

Reading Water Department (Mwra) has not yet reported its service line inventory to EPA (as of the first quarter of 2026). Ask the utility whether your home's service line has been identified.

Other water systems serving parts of Reading

Water systemService linesTotal
Winchester Water DeptNot reported—
Woburn Water Dept.Not reported—

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Reading drinking water violations

EPA records show 1 health-based violation for Reading Water Department since 2016, all since resolved or closed. The most recent began in Oct 2019. It also had 1 monitoring or reporting violation (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Contaminant or ruleTypeViolationsMost recentStatus
Coliform bacteria / E. coli (Revised Total Coliform Rule)
bacteria that signal possible contamination of the system · what it means
Contaminant above legal limit 1 Oct 2019 Resolved/closed

Other water systems serving parts of Reading

Water systemHealth-based violationsMonitoring/reporting
Winchester Water DeptNone12
Woburn Water Dept.None0

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Reading

SiteTypeDistanceMedianSamplesYears
MA-L6W 91 LYNNFIELD, MA
USGS New Hampshire Water Science Center
Well 2.7 mi121 mg/L72001–2019
MAPLE MEADOW BK, AT MIDDLESEX CANAL, WILMINGTON MA
USGS Massachusetts Water Science Center
Stream 2.9 mi78 mg/L102018–2019
MAPLE MEADOW BROOK, WILMINGTON MA
USGS Massachusetts Water Science Center
Stream 3.1 mi87 mg/L132018–2019
SAWMILL BROOK AT CHESTNUT ST, WILMINGTON MA
USGS Massachusetts Water Science Center
Stream 3.5 mi80 mg/L132018–2019
MA-N3W 234
USGS New Hampshire Water Science Center
Well 4.4 mi111 mg/L32001–2019
IPSWICH RIVER AT SOUTH MIDDLETON, MA
USGS Massachusetts Water Science Center
Stream 4.7 mi48 mg/L382000–2016

Water hardness in towns near Reading

TownDistanceMedianClass
Wakefield3 mi 97 mg/LModerately hard
Lynnfield3 mi 87 mg/LModerately hard
Wilmington4 mi 83 mg/LModerately hard
Woburn4 mi 93 mg/LModerately hard
Stoneham4 mi 93 mg/LModerately hard
Burlington5 mi 83 mg/LModerately hard
Melrose6 mi 83 mg/LModerately hard
Winchester6 mi 87 mg/LModerately hard
Saugus7 mi 90 mg/LModerately hard
Peabody7 mi 102 mg/LModerately hard

Middlesex County

Reading is in Middlesex County, where the median is 76 mg/L (moderately hard) across 51 sites.

See all of Middlesex County →

Massachusetts

The statewide median is 53 mg/L (soft) from 321 sites.

Massachusetts hardness map →

Reading, MA water: common questions

Do I need a water softener in Reading?

Probably not. Water measured around Reading is 5.2 gpg (90 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable. If spotting bothers you, about 9,000 grains of capacity covers a 3-person home between weekly regenerations.Size it for your household →

Who supplies Reading's drinking water?

The main public water system serving Reading in EPA records is Reading Water Department. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Reading?

It depends on what you want to remove. In Reading, the system had 1 health-based violation since 2016, for the Revised Total Coliform Rule; the utility's annual report says what was done about it. On the other hand, no PFAS found in EPA testing. A water softener is not a filter.How to read your water quality report →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next