Water hardness in Burlington, MA

Water in Burlington is moderately hard, with a median of 83 mg/L (4.9 grains per gallon) across 27 monitoring sites within 10 miles.

57% harder than the Massachusetts median (53 mg/L) 25th hardest of 88 Massachusetts towns Population 24,498 (2010)
83mg/L
4.9 grains per gallon
Moderately hard

Burlington tap water at a glance

  • HardnessModerately hard (83 mg/L, 4.9 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
  • PFAS1 found in EPA testing; every result with a federal limit was at or below it.PFAS results →
  • ViolationsNo health-based violations since 2016.EPA record →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 83 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 4.9 gpg (4.6 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites27
Lab samples952
Sample years2000–2023
Middle 50% of sites69–102 mg/L
Groundwater (wells, springs)103 mg/L · 7 sites
Surface water (rivers, lakes)80 mg/L · 20 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Burlington

Prefilled with Burlington's measured local hardness of 83 mg/L (4.9 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Burlington tap water

Burlington Water Dept is the main public water system for Burlington. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 8 samples taken Jan 2024 – Oct 2024. 1 PFAS was detected.

ChemicalHighest resultDetected inEPA limit
PFBA
perfluorobutanoic acid
11 ppt 2 of 8 samples —

Other water systems serving parts of Burlington

Water systemPFAS detectedHighest PFOA / PFOSTested
Bedford Water Dept.
serves over 10,000 people
None detected — Jan 2024 – Oct 2024
Hanscom AFB
serves over 10,000 people
None detected — Mar 2023 – Dec 2023
Lexington Water Dept. (Mwra)
serves over 10,000 people
None detected — Jan 2023 – Oct 2023

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Burlington

Burlington Water Dept has not yet reported its service line inventory to EPA (as of the first quarter of 2026). Ask the utility whether your home's service line has been identified.

Other water systems serving parts of Burlington

Water systemService linesTotal
Bedford Water Dept.Not reported—
Hanscom AFBNot reported—
Lexington Water Dept. (Mwra)Not reported—

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Burlington drinking water violations

EPA records show no health-based violations for Burlington Water Dept since 2016. It also had 3 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Other water systems serving parts of Burlington

Water systemHealth-based violationsMonitoring/reporting
Bedford Water Dept.None1
Hanscom AFB12
Lexington Water Dept. (Mwra)None2

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Burlington

SiteTypeDistanceMedianSamplesYears
SAWMILL BROOK AT CHESTNUT ST, WILMINGTON MA
USGS Massachusetts Water Science Center
Stream 2.2 mi80 mg/L132018–2019
MAPLE MEADOW BROOK, WILMINGTON MA
USGS Massachusetts Water Science Center
Stream 2.3 mi87 mg/L132018–2019
MA-A4W 10 BEDFORD, MA
USGS Massachusetts Water Science Center
Well 2.3 mi103 mg/L22012–2019
MAPLE MEADOW BK, AT MIDDLESEX CANAL, WILMINGTON MA
USGS Massachusetts Water Science Center
Stream 2.9 mi78 mg/L102018–2019
MA-XRW 70
USGS Massachusetts Water Science Center
Well 3.4 mi83 mg/L12011
MA-XRW 68
USGS New Hampshire Water Science Center
Well 3.4 mi69 mg/L12001

Water hardness in towns near Burlington

TownDistanceMedianClass
Woburn3 mi 93 mg/LModerately hard
Lexington4 mi 80 mg/LModerately hard
Winchester5 mi 87 mg/LModerately hard
Wilmington5 mi 83 mg/LModerately hard
Reading5 mi 90 mg/LModerately hard
Stoneham6 mi 93 mg/LModerately hard
Arlington6 mi 82 mg/LModerately hard
Wakefield7 mi 97 mg/LModerately hard
Medford7 mi 83 mg/LModerately hard
Belmont8 mi 82 mg/LModerately hard

Middlesex County

Burlington is in Middlesex County, where the median is 76 mg/L (moderately hard) across 51 sites.

See all of Middlesex County →

Massachusetts

The statewide median is 53 mg/L (soft) from 321 sites.

Massachusetts hardness map →

Burlington, MA water: common questions

Do I need a water softener in Burlington?

Probably not. Water measured around Burlington is 4.9 gpg (83 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable. If spotting bothers you, about 9,000 grains of capacity covers a 3-person home between weekly regenerations.Size it for your household →

Who supplies Burlington's drinking water?

The main public water system serving Burlington in EPA records is Burlington Water Dept. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Burlington?

It depends on what you want to remove. In Burlington, EPA testing found PFBA in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS. On the other hand, no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next