Water hardness in Valley County, ID
Water in Valley County is soft, with a median of 39 mg/L (2.3 grains per gallon) across 81 monitoring sites.
Valley County water at a glance
- HardnessSoft (39 mg/L, 2.3 gpg, local measurements). A water softener isn't needed.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 39 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 2.3 gpg (2.2 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Valley County
Prefilled with Valley County's measured local hardness of 39 mg/L (2.3 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Valley County on the Idaho map
Cities and communities in Valley County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| McCall | 44 | Soft | 14 sites within 10 miles |
| Cascade | 14 | Soft | 7 sites within 10 miles |
| Donnelly | 24 | Soft | 10 sites within 10 miles |
| Smiths Ferry (CDP) | 15 | Soft | 4 sites within 10 miles |
| Yellow Pine (CDP) | 43 | Soft | 58 sites within 10 miles |
Water quality in Valley County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| McCall | City of Mccall | None detected | 2 lead · 1,402 unknown | 12 |
| Cascade | City of Cascade | Not tested | 0 lead · 554 unknown | None |
| Donnelly | City of Donnelly | Not tested | 0 lead · 0 unknown | None |
Neighboring counties
- Adams County58 mg/L
- Boise County34 mg/L
- Washington County102 mg/L
- Gem County87 mg/L
- Idaho County98 mg/L
- Custer County88 mg/L
Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.