Water hardness in Franklin County, ID

Water in Franklin County is very hard, with a median of 315 mg/L (18.4 grains per gallon) across 41 monitoring sites.

106% harder than the Idaho median (153 mg/L) 2nd hardest of 44 counties
315mg/L
18.4 grains per gallon
Very hard

Franklin County water at a glance

  • HardnessVery hard (315 mg/L, 18.4 gpg, local measurements). Water softeners are common at this level.Size a water softener →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 315 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 18.4 gpg (17.6 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites41
Lab samples285
Sample years2000–2015
Middle 50% of sites225–352 mg/L
Groundwater (wells, springs)232 mg/L · 16 sites
Surface water (rivers, lakes)317 mg/L · 25 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Franklin County

Prefilled with Franklin County's measured local hardness of 315 mg/L (18.4 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Franklin County on the Idaho map

Latah CountyIdaho CountyBoundary CountyLincoln CountyMadison CountyCuster CountyValley CountyJefferson CountyLemhi CountyClearwater CountyAdams CountyOneida CountyClark CountyShoshone CountyElmore CountyBoise CountyMinidoka CountyBenewah CountyCassia CountyWashington CountyButte CountyBlaine CountyOwyhee CountyCanyon CountyJerome CountyNez Perce CountyBonneville CountyBonner CountyGem CountyTwin Falls CountyFremont CountyCamas CountyGooding CountyBannock CountyKootenai CountyPower CountyTeton CountyAda CountyBear Lake CountyLewis CountyPayette CountyBingham CountyCaribou County

Cities and communities in Franklin County

PlaceMedian mg/LClassBased on
Preston 309 Very hard 32 sites within 10 miles
Franklin 279 Very hard 17 sites within 10 miles
Weston 318 Very hard 24 sites within 10 miles
Dayton 318 Very hard 26 sites within 10 miles
Clifton 326 Very hard 19 sites within 10 miles
Oxford 272 Very hard 8 sites within 10 miles

Water quality in Franklin County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Preston City of Preston None detected 0 lead · 0 unknown 3
Franklin City of Franklin Not tested 0 lead · 0 unknown 2
Weston City of Weston Not tested 0 lead · 0 unknown None
Dayton City of Dayton Not tested 0 lead · 0 unknown None
Clifton City of Clifton Not tested 0 lead · 4 unknown 2

Neighboring counties

Idaho

The statewide median is 153 mg/L (hard) from 2,809 sites.

Idaho hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next