Water hardness in Custer County, ID

Water in Custer County is moderately hard, with a median of 88 mg/L (5.1 grains per gallon) across 42 monitoring sites.

42% softer than the Idaho median (153 mg/L) 35th hardest of 44 counties
88mg/L
5.1 grains per gallon
Moderately hard

Custer County water at a glance

  • HardnessModerately hard (88 mg/L, 5.1 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 88 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 5.1 gpg (4.9 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites42
Lab samples207
Sample years2000–2018
Middle 50% of sites36–172 mg/L
Groundwater (wells, springs)145 mg/L · 32 sites
Surface water (rivers, lakes)37 mg/L · 10 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Custer County

Prefilled with Custer County's measured local hardness of 88 mg/L (5.1 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Custer County on the Idaho map

Latah CountyIdaho CountyBoundary CountyLincoln CountyMadison CountyValley CountyJefferson CountyLemhi CountyClearwater CountyAdams CountyOneida CountyClark CountyShoshone CountyElmore CountyBoise CountyMinidoka CountyBenewah CountyCassia CountyWashington CountyButte CountyBlaine CountyOwyhee CountyCanyon CountyJerome CountyNez Perce CountyBonneville CountyFranklin CountyBonner CountyGem CountyTwin Falls CountyFremont CountyCamas CountyGooding CountyBannock CountyKootenai CountyPower CountyTeton CountyAda CountyBear Lake CountyLewis CountyPayette CountyBingham CountyCaribou County

Cities and communities in Custer County

PlaceMedian mg/LClassBased on
Challis 238 Very hard 8 sites within 10 miles
Mackay 157 Hard 4 sites within 10 miles
Stanley 28 Soft 6 sites within 10 miles
Lost River 980 Very hard 20 sites within 10 miles
Clayton 144 Hard 3 sites within 10 miles

Water quality in Custer County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Challis City of Challis Not tested 0 lead · 0 unknown None
Mackay City of Mackay Not tested 0 lead · 0 unknown None

Neighboring counties

Idaho

The statewide median is 153 mg/L (hard) from 2,809 sites.

Idaho hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next