Water hardness in Teton County, ID

Water in Teton County is very hard, with a median of 196 mg/L (11.4 grains per gallon) across 15 monitoring sites.

28% harder than the Idaho median (153 mg/L) 16th hardest of 44 counties
196mg/L
11.4 grains per gallon
Very hard

Teton County water at a glance

  • HardnessVery hard (196 mg/L, 11.4 gpg, local measurements). Water softeners are common at this level.Size a water softener →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 196 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 11.4 gpg (11 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites15
Lab samples40
Sample years2000–2011
Middle 50% of sites146–218 mg/L
Groundwater (wells, springs)196 mg/L · 15 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Teton County

Prefilled with Teton County's measured local hardness of 196 mg/L (11.5 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Teton County on the Idaho map

Latah CountyIdaho CountyBoundary CountyLincoln CountyMadison CountyCuster CountyValley CountyJefferson CountyLemhi CountyClearwater CountyAdams CountyOneida CountyClark CountyShoshone CountyElmore CountyBoise CountyMinidoka CountyBenewah CountyCassia CountyWashington CountyButte CountyBlaine CountyOwyhee CountyCanyon CountyJerome CountyNez Perce CountyBonneville CountyFranklin CountyBonner CountyGem CountyTwin Falls CountyFremont CountyCamas CountyGooding CountyBannock CountyKootenai CountyPower CountyAda CountyBear Lake CountyLewis CountyPayette CountyBingham CountyCaribou County

Cities and communities in Teton County

PlaceMedian mg/LClassBased on
Victor 214 Very hard 4 sites within 10 miles
Driggs 196 Very hard 11 sites within 10 miles
Tetonia 186 Very hard 13 sites within 10 miles

Water quality in Teton County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Victor City of Victor Not tested 0 lead · 2 unknown None
Driggs Ironwood Not tested 0 lead · 0 unknown None
Tetonia City of Tetonia Not tested 0 lead · 0 unknown None

Neighboring counties

Idaho

The statewide median is 153 mg/L (hard) from 2,809 sites.

Idaho hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next