Water hardness in Jerome County, ID

Water in Jerome County is very hard, with a median of 234 mg/L (13.6 grains per gallon) across 87 monitoring sites.

53% harder than the Idaho median (153 mg/L) 10th hardest of 44 counties
234mg/L
13.6 grains per gallon
Very hard

Jerome County water at a glance

  • HardnessVery hard (234 mg/L, 13.6 gpg, local measurements). Water softeners are common at this level.Size a water softener →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 234 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 13.6 gpg (13.1 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites87
Lab samples198
Sample years2000–2020
Middle 50% of sites172–257 mg/L
Groundwater (wells, springs)234 mg/L · 85 sites
Surface water (rivers, lakes)226 mg/L · 2 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Jerome County

Prefilled with Jerome County's measured local hardness of 234 mg/L (13.7 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Jerome County on the Idaho map

Latah CountyIdaho CountyBoundary CountyLincoln CountyMadison CountyCuster CountyValley CountyJefferson CountyLemhi CountyClearwater CountyAdams CountyOneida CountyClark CountyShoshone CountyElmore CountyBoise CountyMinidoka CountyBenewah CountyCassia CountyWashington CountyButte CountyBlaine CountyOwyhee CountyCanyon CountyNez Perce CountyBonneville CountyFranklin CountyBonner CountyGem CountyTwin Falls CountyFremont CountyCamas CountyGooding CountyBannock CountyKootenai CountyPower CountyTeton CountyAda CountyBear Lake CountyLewis CountyPayette CountyBingham CountyCaribou County

Cities and communities in Jerome County

PlaceMedian mg/LClassBased on
Jerome 228 Very hard 76 sites within 10 miles
Hazelton 236 Very hard 34 sites within 10 miles
Eden 236 Very hard 44 sites within 10 miles

Water quality in Jerome County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Jerome City of Jerome None detected 0 lead · 2,409 unknown None
Hazelton City of Hazelton Not tested 0 lead · 0 unknown None
Eden City of Eden Not tested 0 lead · 0 unknown None

Neighboring counties

Idaho

The statewide median is 153 mg/L (hard) from 2,809 sites.

Idaho hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next