Water hardness in Oxford, AL
Water in Oxford is moderately hard, with a median of 71 mg/L (4.2 grains per gallon) across 28 monitoring sites within 10 miles.
Oxford tap water at a glance
- HardnessModerately hard (71 mg/L, 4.2 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
- PFAS2 found; the highest PFOS result was above EPA's 4 ppt limit (a single result is not a violation).Filters that remove PFAS →
- Lead pipesNo known lead lines; 3,573 lines are still of unknown material.Check your own pipe →
- Violations1 health-based violation since 2016.What they were →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 71 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 4.2 gpg (4 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Oxford
Prefilled with Oxford's measured local hardness of 71 mg/L (4.2 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Oxford tap water
Oxford Water Works & Sewer Board is the main public water system for Oxford. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 14 samples taken Feb 2024 – Nov 2024. 2 PFAS were detected. The highest PFOS result was above EPA's drinking water limit (4 ppt).
| Chemical | Highest result | Detected in | EPA limit |
|---|---|---|---|
| PFOS perfluorooctane sulfonic acid | 6.1 ppt | 6 of 14 samples | 4 ppt |
| PFHxS perfluorohexane sulfonic acid | 3.1 ppt | 1 of 14 samples | 10 ppt* |
Other water systems serving parts of Oxford
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| Anniston Water & Sewer Board serves over 10,000 people | None detected | — | Sep 2024 – May 2025 |
| Calhoun County Water & Fire PR Authority serves over 10,000 people | None detected | — | Jun 2024 – Feb 2025 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Oxford
Oxford Water Works & Sewer Board reported 10,183 service lines (the pipes connecting homes to the water main) in its inventory. 0 are lead and 618 are galvanized lines that must be replaced, and 3,573 are still of unknown material.
EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask Oxford Water Works & Sewer Board whether your address is on its list.
Other water systems serving parts of Oxford
| Water system | Service lines | Total |
|---|---|---|
| Anniston Alabama, the WWSB of the City O | 0 lead · 0 galvanized · 0 unknown | 23,523 |
| Calhoun County Water Authority | 0 lead · 0 galvanized · 0 unknown | 11,002 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Oxford drinking water violations
EPA records show 1 health-based violation for Oxford Water Works & Sewer Board since 2016, all since resolved or closed. The most recent began in Apr 2024. It also had 22 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.
| Contaminant or rule | Type | Violations | Most recent | Status |
|---|---|---|---|---|
| Trichloroethylene (TCE) an industrial solvent highest measured 0.012 MG/L; limit 0.005 mg/L | Contaminant above legal limit | 1 | Apr 2024 | Resolved/closed |
Other water systems serving parts of Oxford
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| Anniston Water & Sewer Board | None | 1 |
| Calhoun County Water & Fire PR Authority | None | 0 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Oxford
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| CHOT-6 ALABAMA DEPT. OF ENVIRONMENTAL MANAGEMENT - WATER QUALITY DATA | River/Stream | 1.4 mi | 66 mg/L | 4 | 2022 |
| CHOT-2 ALABAMA DEPT. OF ENVIRONMENTAL MANAGEMENT - WATER QUALITY DATA | River/Stream | 1.9 mi | 66 mg/L | 4 | 2022 |
| Collateral Springs @ Oxford USGS Alabama Water Science Center | Spring | 2 mi | 160 mg/L | 3 | 2001–2003 |
| CL-2 ALABAMA DEPT. OF ENVIRONMENTAL MANAGEMENT - WATER QUALITY DATA | River/Stream | 2.4 mi | 66 mg/L | 3 | 2022 |
| UCHC-1 ALABAMA DEPT. OF ENVIRONMENTAL MANAGEMENT - WATER QUALITY DATA | River/Stream | 2.5 mi | 128 mg/L | 8 | 2017–2025 |
| SNOW CREEK BELOW ANNISTON, ALA USGS Alabama Water Science Center | Stream | 2.8 mi | 128 mg/L | 3 | 2000–2001 |
Water hardness in towns near Oxford
| Town | Distance | Median | Class |
|---|---|---|---|
| Anniston | 6 mi | 100 mg/L | Moderately hard |
| Saks | 8 mi | 117 mg/L | Moderately hard |
| Jacksonville | 16 mi | 114 mg/L | Moderately hard |
| Talladega | 18 mi | 81 mg/L | Moderately hard |
| Pell City | 23 mi | 68 mg/L | Moderately hard |
| Rainbow City | 26 mi | 77 mg/L | Moderately hard |
| Gadsden | 30 mi | 102 mg/L | Moderately hard |
| Moody | 36 mi | 99 mg/L | Moderately hard |
| Sylacauga | 37 mi | 108 mg/L | Moderately hard |
| Trussville | 40 mi | 136 mg/L | Hard |
Calhoun County
Oxford is in Calhoun County, where the median is 107 mg/L (moderately hard) across 47 sites.
See all of Calhoun County →Oxford, AL water: common questions
Do I need a water softener in Oxford?
Probably not. Water measured around Oxford is 4.2 gpg (71 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable. If spotting bothers you, about 8,000 grains of capacity covers a 3-person home between weekly regenerations.Size it for your household →
Who supplies Oxford's drinking water?
The main public water system serving Oxford in EPA records is Oxford Water Works & Sewer Board. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →
Do I need a water filter in Oxford?
It depends on what you want to remove. In Oxford, EPA testing found PFOS and PFHxS in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS; the system had 1 health-based violation since 2016, for Trichloroethylene; the utility's annual report says what was done about it. On the other hand, no lead service lines reported. A water softener is not a filter.Filters that remove PFAS →
Hardness scale
What to read next
- Which water filters remove PFAS?EPA tests found 2 PFAS in Oxford's main water system.
- How to tell if your home has a lead pipe3,573 service lines here are of unknown material.
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.