Water hardness in Anniston, AL

Water in Anniston is moderately hard, with a median of 100 mg/L (5.8 grains per gallon) across 29 monitoring sites within 10 miles.

122% harder than the Alabama median (45 mg/L) 29th hardest of 69 Alabama towns Population 21,167
100mg/L
5.8 grains per gallon
Moderately hard

Anniston tap water at a glance

  • HardnessModerately hard (100 mg/L, 5.8 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
  • PFASNone found in EPA's nationwide testing of the main water system.PFAS results →
  • Lead pipesNo lead service lines reported.Details →
  • ViolationsNo health-based violations since 2016.EPA record →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 100 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 5.8 gpg (5.6 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites29
Lab samples142
Sample years2000–2025
Middle 50% of sites53–128 mg/L
Groundwater (wells, springs)117 mg/L · 13 sites
Surface water (rivers, lakes)71 mg/L · 16 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Anniston

Prefilled with Anniston's measured local hardness of 100 mg/L (5.8 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Anniston tap water

Anniston Water & Sewer Board is the main public water system for Anniston. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 8 samples taken Sep 2024 – May 2025. No PFAS were found at or above EPA's minimum reporting levels.

Other water systems serving parts of Anniston

Water systemPFAS detectedHighest PFOA / PFOSTested
Calhoun County Water & Fire PR Authority
serves over 10,000 people
None detected — Jun 2024 – Feb 2025
Oxford Water Works & Sewer Board
serves over 10,000 people
PFOS, PFHxS ND / 6.1 ppt Feb 2024 – Nov 2024

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Anniston

Anniston Alabama, the WWSB of the City O reported 23,523 service lines (the pipes connecting homes to the water main) in its inventory. It reported no lead or galvanized lines requiring replacement.

0lead (0%)
0galvanized requiring replacement
0unknown material (0%)
23,523not lead (100%)

Other water systems serving parts of Anniston

Water systemService linesTotal
Calhoun County Water Authority0 lead · 0 galvanized · 0 unknown11,002
Oxford Water Works & Sewer Board0 lead · 618 galvanized · 3,573 unknown10,183

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Anniston drinking water violations

EPA records show no health-based violations for Anniston Water & Sewer Board since 2016. It also had 1 monitoring or reporting violation (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Other water systems serving parts of Anniston

Water systemHealth-based violationsMonitoring/reporting
Calhoun County Water & Fire PR AuthorityNone0
Oxford Water Works & Sewer Board122

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Anniston

SiteTypeDistanceMedianSamplesYears
Well ACC Well Calhoun Cnty AL
USGS Alabama Water Science Center
Well 2 mi144 mg/L12001
Well CAL 1 334218085491701 Calhoun Cnty AL
USGS Alabama Water Science Center
Well 2.2 mi242 mg/L12001
CNCC-2
ALABAMA DEPT. OF ENVIRONMENTAL MANAGEMENT - WATER QUALITY DATA
River/Stream 3.7 mi76 mg/L62005
Camp Lee Spring
USGS Alabama Water Science Center
Spring 3.9 mi1 mg/L32001–2002
Well Camp Lee Well Calhoun Cnty AL
USGS Alabama Water Science Center
Well 4 mi3 mg/L12001
SNOW CREEK BELOW ANNISTON, ALA
USGS Alabama Water Science Center
Stream 4.1 mi128 mg/L32000–2001

Water hardness in towns near Anniston

TownDistanceMedianClass
Saks4 mi 117 mg/LModerately hard
Oxford6 mi 71 mg/LModerately hard
Jacksonville10 mi 114 mg/LModerately hard
Talladega24 mi 81 mg/LModerately hard
Rainbow City24 mi 77 mg/LModerately hard
Gadsden26 mi 102 mg/LModerately hard
Pell City27 mi 68 mg/LModerately hard
Moody40 mi 99 mg/LModerately hard
Boaz41 mi 31 mg/LSoft
Sylacauga43 mi 108 mg/LModerately hard

Calhoun County

Anniston is in Calhoun County, where the median is 107 mg/L (moderately hard) across 47 sites.

See all of Calhoun County →

Alabama

The statewide median is 45 mg/L (soft) from 2,227 sites.

Alabama hardness map →

Anniston, AL water: common questions

Do I need a water softener in Anniston?

Probably not. Water measured around Anniston is 5.8 gpg (100 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable. If spotting bothers you, about 10,000 grains of capacity covers a 3-person home between weekly regenerations.Size it for your household →

Who supplies Anniston's drinking water?

The main public water system serving Anniston in EPA records is Anniston Water & Sewer Board. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Anniston?

Not for anything in EPA's records: no PFAS found in EPA testing, no lead service lines reported and no health-based violations since 2016. People here who use a filter usually do it for taste, such as chlorine.Chlorine taste in tap water →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next