Water hardness in Teton County, WY

Water in Teton County is moderately hard, with a median of 106 mg/L (6.2 grains per gallon) across 67 monitoring sites.

45% softer than the Wyoming median (192 mg/L) 21st hardest of 23 counties
106mg/L
6.2 grains per gallon
Moderately hard

Teton County water at a glance

  • HardnessModerately hard (106 mg/L, 6.2 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 106 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 6.2 gpg (5.9 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites67
Lab samples527
Sample years2000–2023
Middle 50% of sites83–151 mg/L
Groundwater (wells, springs)135 mg/L · 32 sites
Surface water (rivers, lakes)99 mg/L · 35 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Teton County

Prefilled with Teton County's measured local hardness of 106 mg/L (6.2 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Teton County on the Wyoming map

Lincoln CountyPlatte CountyWashakie CountyPark CountyUinta CountyCampbell CountyConverse CountyGoshen CountyNatrona CountyNiobrara CountySweetwater CountySublette CountyBig Horn CountyHot Springs CountyAlbany CountyFremont CountyCarbon CountyCrook CountyLaramie CountyJohnson CountySheridan CountyWeston County

Cities and communities in Teton County

PlaceMedian mg/LClassBased on
Jackson 151 Hard 18 sites within 10 miles
Moose Wilson Road (CDP) 142 Hard 20 sites within 10 miles
South Park (CDP) 168 Hard 5 sites within 10 miles
Wilson (CDP) 106 Moderately hard county median
Hoback (CDP) 898 Very hard 3 sites within 10 miles
Rafter J Ranch (CDP) 168 Hard 5 sites within 10 miles
Alta (CDP) 106 Moderately hard county median
Teton Village (CDP) 118 Moderately hard 27 sites within 10 miles
Kelly (CDP) 128 Hard 30 sites within 10 miles

Water quality in Teton County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Jackson Town of Jackson 1 found 0 lead · 1,139 unknown None
Wilson Wilson Park Subdivision Not tested 0 lead · 0 unknown None
Alta Targhee Towne Water District Not tested 0 lead · 0 unknown None
Teton Village Teton Village Water & Sewer District Not tested 0 lead · 0 unknown None

Neighboring counties

Wyoming

The statewide median is 192 mg/L (very hard) from 810 sites.

Wyoming hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next