Water hardness in Crook County, WY

Water in Crook County is very hard, with a median of 582 mg/L (34 grains per gallon) across 25 monitoring sites.

203% harder than the Wyoming median (192 mg/L) 1st hardest of 23 counties
582mg/L
34 grains per gallon
Very hard

Crook County water at a glance

  • HardnessVery hard (582 mg/L, 34 gpg, local measurements). Water softeners are common at this level.Size a water softener →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 582 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 34 gpg (32.6 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites25
Lab samples603
Sample years2000–2023
Middle 50% of sites368–922 mg/L
Groundwater (wells, springs)560 mg/L · 21 sites
Surface water (rivers, lakes)862 mg/L · 4 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Crook County

Prefilled with Crook County's measured local hardness of 582 mg/L (34 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Crook County on the Wyoming map

Lincoln CountyPlatte CountyWashakie CountyPark CountyUinta CountyCampbell CountyConverse CountyGoshen CountyTeton CountyNatrona CountyNiobrara CountySweetwater CountySublette CountyBig Horn CountyHot Springs CountyAlbany CountyFremont CountyCarbon CountyLaramie CountyJohnson CountySheridan CountyWeston County

Cities and communities in Crook County

PlaceMedian mg/LClassBased on
Sundance 1,605 Very hard 5 sites within 10 miles
Moorcroft 393 Very hard 9 sites within 10 miles
Pine Haven 403 Very hard 4 sites within 10 miles
Hulett 582 Very hard county median
Beulah (CDP) 642 Very hard 5 sites within 10 miles

Water quality in Crook County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Sundance City of Sundance Not tested 0 lead · 446 unknown 1
Moorcroft Town of Moorcroft Not tested 0 lead · 203 unknown 2
Pine Haven Town of Pine Haven Not tested 0 lead · 224 unknown None
Hulett Town of Hulett Not tested 0 lead · 413 unknown None
Beulah Beulah Land Water Not tested 0 lead · 0 unknown 3 (2 open)

Neighboring counties

Wyoming

The statewide median is 192 mg/L (very hard) from 810 sites.

Wyoming hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next