Water hardness in Port Washington, WI

Water in Port Washington is very hard, with a median of 318 mg/L (18.6 grains per gallon) across Ozaukee County.

115% harder than the Wisconsin median (148 mg/L) 25th hardest of 97 Wisconsin towns Population 12,763
318mg/L
18.6 grains per gallon
Very hard

There are not enough monitoring sites within 10 miles of Port Washington, so this page uses the Ozaukee County median.

Port Washington tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 318 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 18.6 gpg (17.8 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites3
Lab samples15
Sample years2003–2018
Middle 50% of sites309–351 mg/L
Groundwater (wells, springs)384 mg/L · 1 sites
Surface water (rivers, lakes)309 mg/L · 2 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Port Washington

Prefilled with Port Washington's measured local hardness of 318 mg/L (18.6 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Port Washington tap water

Port Washington Waterworks is the main public water system for Port Washington. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Jan 2023 – Oct 2023. No PFAS were found at or above EPA's minimum reporting levels.

Other water systems serving parts of Port Washington

Water systemPFAS detectedHighest PFOA / PFOSTested
Grafton Waterworks
serves over 10,000 people
None detected — Oct 2023 – Sep 2024

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Port Washington

Port Washington Waterworks reported 4,087 service lines (the pipes connecting homes to the water main) in its inventory. 249 are lead and 102 are galvanized lines that must be replaced, and 897 are still of unknown material.

249lead (6%)
102galvanized requiring replacement
897unknown material (22%)
2,839not lead (69%)

EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask Port Washington Waterworks whether your address is on its list.

Other water systems serving parts of Port Washington

Water systemService linesTotal
Grafton Waterworks0 lead · 0 galvanized · 0 unknown4,444

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Port Washington drinking water violations

EPA records show no health-based violations for Port Washington Waterworks since 2016. It also had 4 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Other water systems serving parts of Port Washington

Water systemHealth-based violationsMonitoring/reporting
Grafton WaterworksNone0

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Port Washington

SiteTypeDistanceMedianSamplesYears
MILWAUKEE RIVER NEAR CEDARBURG, WI
USGS Wisconsin Water Science Center
Stream 7.8 mi318 mg/L122004–2005
CEDAR CREEK AT GREEN BAY ROAD AT CEDARBURG, WI
USGS Wisconsin Water Science Center
Stream 8.3 mi300 mg/L12018

Water hardness in towns near Port Washington

TownDistanceMedianClass
Grafton5 mi 300 mg/LVery hard
Cedarburg8 mi 295 mg/LVery hard
Mequon14 mi 298 mg/LVery hard
West Bend15 mi 304 mg/LVery hard
Brown Deer15 mi 300 mg/LVery hard
Germantown16 mi 346 mg/LVery hard
Glendale18 mi 244 mg/LVery hard
Whitefish Bay19 mi 242 mg/LVery hard
Menomonee Falls20 mi 335 mg/LVery hard
Richfield20 mi 266 mg/LVery hard

Ozaukee County

Port Washington is in Ozaukee County, where the median is 318 mg/L (very hard) across 3 sites.

See all of Ozaukee County →

Wisconsin

The statewide median is 148 mg/L (hard) from 1,102 sites.

Wisconsin hardness map →

Port Washington, WI water: common questions

Do I need a water softener in Port Washington?

Very likely. Water measured around Port Washington is 18.6 gpg (318 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 33,000 grains.Size it for your household →

Who supplies Port Washington's drinking water?

The main public water system serving Port Washington in EPA records is Port Washington Waterworks. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Port Washington?

It depends on what you want to remove. In Port Washington, the system reports 249 lead service lines; if your home has one, a filter certified to remove lead is the usual step until the line is replaced. On the other hand, no PFAS found in EPA testing and no health-based violations since 2016. A water softener is not a filter.Check your own service line →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next