Water hardness in Plover, WI
Water in Plover is hard, with a median of 150 mg/L (8.8 grains per gallon) across 7 monitoring sites within 10 miles.
Plover tap water at a glance
- HardnessHard (150 mg/L, 8.8 gpg, local measurements). Scale on fixtures, kettles and water heaters is likely.Size a water softener →
- PFAS1 found in EPA testing; every result with a federal limit was at or below it.PFAS results →
- Lead pipesNo lead service lines reported.Details →
- Violations1 health-based violation since 2016.What they were →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 150 mg/L means at home
- Water softener: Many households here choose a softener to protect water heaters and appliances from scale.
- Dishwasher: set the water hardness to about 8.8 gpg (8.4 °dH), which is a medium-to-high hardness setting, with rinse aid.
- Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
- Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
- Water heater: flush the tank once a year to clear sediment and scale.
Size a softener for your home → Hard water and your water heater →
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Plover
Prefilled with Plover's measured local hardness of 150 mg/L (8.8 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Plover tap water
Plover Waterworks is the main public water system for Plover. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 6 samples taken Sep 2023 – Mar 2024. 1 PFAS was detected.
| Chemical | Highest result | Detected in | EPA limit |
|---|---|---|---|
| PFBA perfluorobutanoic acid | 7.5 ppt | 2 of 6 samples | — |
Other water systems serving parts of Plover
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| Stevens Point Waterworks serves over 10,000 people | None detected | — | Nov 2023 – May 2024 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Plover
Plover Waterworks reported 5,032 service lines (the pipes connecting homes to the water main) in its inventory. It reported no lead or galvanized lines requiring replacement.
Other water systems serving parts of Plover
| Water system | Service lines | Total |
|---|---|---|
| Stevens Point Waterworks | 0 lead · 0 galvanized · 95 unknown | 5,758 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Plover drinking water violations
EPA records show 1 health-based violation for Plover Waterworks since 2016, all since resolved or closed. The most recent began in Jan 2019.
| Contaminant or rule | Type | Violations | Most recent | Status |
|---|---|---|---|---|
| Groundwater Rule requirements to protect well water from fecal contamination | Treatment requirement not met | 1 | Jan 2019 | Resolved/closed |
Other water systems serving parts of Plover
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| Stevens Point Waterworks | None | 2 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Plover
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| Mcdill Pond - Deep Hole Wisconsin Department of Natural Resources | Lake | 2.5 mi | 190 mg/L | 1 | 2000 |
| Wisconsin River at Stevens Point Dam Wisconsin Department of Natural Resources | River/Stream | 4.5 mi | 44 mg/L | 12 | 2000–2001 |
| Joanis Lake - Center Wisconsin Department of Natural Resources | Lake | 5.2 mi | 59 mg/L | 5 | 2024–2026 |
| Mill Creek at Cth P Wisconsin Department of Natural Resources | River/Stream | 5.7 mi | 150 mg/L | 2 | 2000–2001 |
| Unnamed (Eagle Pointe) Lake - Center of Lake Wisconsin Department of Natural Resources | Lake | 6.3 mi | 108 mg/L | 1 | 2025 |
| PT-23/09E/26-1321 USGS Wisconsin Water Science Center | Well | 8.2 mi | 425 mg/L | 3 | 2002–2023 |
Water hardness in towns near Plover
| Town | Distance | Median | Class |
|---|---|---|---|
| Stevens Point | 4 mi | 275 mg/L | Very hard |
| Wisconsin Rapids | 15 mi | 140 mg/L | Hard |
| Weston | 30 mi | 46 mg/L | Soft |
| Marshfield | 34 mi | 209 mg/L | Very hard |
| Wausau | 35 mi | 51 mg/L | Soft |
| Greenville | 50 mi | 302 mg/L | Very hard |
| Fox Crossing | 55 mi | 180 mg/L | Hard |
| Neenah | 56 mi | 274 mg/L | Very hard |
| Oshkosh | 57 mi | 222 mg/L | Very hard |
| Menasha | 58 mi | 180 mg/L | Hard |
Portage County
Plover is in Portage County, where the median is 267 mg/L (very hard) across 70 sites.
See all of Portage County →Plover, WI water: common questions
Do I need a water softener in Plover?
Many homes here use one. Water measured around Plover is 8.8 gpg (150 mg/L, measured locally), above the 7 gpg (120 mg/L) level where scale on fixtures, appliances and water heaters becomes noticeable. For a 3-person home that regenerates weekly, that means a softener of about 16,000 grains.Size it for your household →
Who supplies Plover's drinking water?
The main public water system serving Plover in EPA records is Plover Waterworks. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →
Do I need a water filter in Plover?
It depends on what you want to remove. In Plover, EPA testing found PFBA in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS; the system had 1 health-based violation since 2016, for the Groundwater Rule; the utility's annual report says what was done about it. On the other hand, no lead service lines reported. A water softener is not a filter.Filters that remove PFAS →
Hardness scale
What to read next
- Do you need a water softener?Water here is hard; size a softener with our calculator.
- Which water filters remove PFAS?EPA tests found 1 PFAS in Plover's main water system.
- Hard water and your water heaterHow scale affects your water heater and how often to flush.
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.