Water hardness in Mount Pleasant, WI

Water in Mount Pleasant is very hard, with a median of 324 mg/L (18.9 grains per gallon) across Racine County.

119% harder than the Wisconsin median (148 mg/L) 23rd hardest of 97 Wisconsin towns Population 27,727
324mg/L
18.9 grains per gallon
Very hard

There are not enough monitoring sites within 10 miles of Mount Pleasant, so this page uses the Racine County median.

Mount Pleasant tap water at a glance

  • HardnessVery hard (324 mg/L, 18.9 gpg, local measurements). Water softeners are common at this level.Size a water softener →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 324 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 18.9 gpg (18.2 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites16
Lab samples121
Sample years2000–2023
Middle 50% of sites244–414 mg/L
Groundwater (wells, springs)356 mg/L · 11 sites
Surface water (rivers, lakes)230 mg/L · 5 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Mount Pleasant

Prefilled with Mount Pleasant's measured local hardness of 324 mg/L (18.9 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Mount Pleasant tap water

Mount Pleasant is served by more than one water system. These systems supply ZIP codes in Mount Pleasant and were tested for PFAS ("forever chemicals") in EPA's nationwide UCMR 5 study. Check your water bill to see which one is yours.

Water systems serving Mount Pleasant

Water systemPFAS detectedHighest PFOA / PFOSTested
Racine Waterworks
serves over 10,000 people
None detected — Jan 2023 – Oct 2023
Village of Caledonia Water Utility -
serves over 10,000 people
None detected — Nov 2024 – Aug 2025

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Mount Pleasant

Mount Pleasant is served by more than one water system. Their service line inventories, as reported to EPA:

Water systems serving Mount Pleasant

Water systemService linesTotal
Racine Waterworks10,257 lead · 394 galvanized · 1 unknown33,837
Village of Caledonia Water Utility -0 lead · 0 galvanized · 0 unknown8,305

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Mount Pleasant drinking water violations

Mount Pleasant is served by more than one water system. Health-based violations recorded by EPA since 2016:

Water systems serving Mount Pleasant

Water systemHealth-based violationsMonitoring/reporting
Racine WaterworksNone0
Village of Caledonia Water Utility -13

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Mount Pleasant

SiteTypeDistanceMedianSamplesYears
ROOT RIVER - ROOT RIVER AT JOHNSON PARK
Wisconsin Department of Natural Resources
River/Stream 4.8 mi358 mg/L652000–2012

Water hardness in towns near Mount Pleasant

TownDistanceMedianClass
Racine4 mi 324 mg/LVery hard
Caledonia6 mi 358 mg/LVery hard
Kenosha8 mi 270 mg/LVery hard
Oak Creek12 mi 302 mg/LVery hard
Pleasant Prairie13 mi 270 mg/LVery hard
Franklin14 mi 270 mg/LVery hard
South Milwaukee14 mi 245 mg/LVery hard
Cudahy16 mi 252 mg/LVery hard
Muskego17 mi 278 mg/LVery hard
Greendale17 mi 253 mg/LVery hard

Racine County

Mount Pleasant is in Racine County, where the median is 324 mg/L (very hard) across 16 sites.

See all of Racine County →

Wisconsin

The statewide median is 148 mg/L (hard) from 1,102 sites.

Wisconsin hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next