Water hardness in Chippewa Falls, WI

Water in Chippewa Falls is soft, with a median of 53 mg/L (3.1 grains per gallon) across 6 monitoring sites within 10 miles.

64% softer than the Wisconsin median (148 mg/L) 95th hardest of 97 Wisconsin towns Population 14,656
53mg/L
3.1 grains per gallon
Soft

Chippewa Falls tap water at a glance

  • HardnessSoft (53 mg/L, 3.1 gpg, local measurements). A water softener isn't needed.Water heater care →
  • PFAS1 found in EPA testing; every result with a federal limit was at or below it.PFAS results →
  • Lead pipesNo lead service lines reported.Details →
  • ViolationsNo health-based violations since 2016.EPA record →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 53 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 3.1 gpg (3 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites6
Lab samples33
Sample years2000–2013
Middle 50% of sites40–64 mg/L
Groundwater (wells, springs)122 mg/L · 1 sites
Surface water (rivers, lakes)44 mg/L · 5 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Chippewa Falls

Prefilled with Chippewa Falls's measured local hardness of 53 mg/L (3.1 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Chippewa Falls tap water

Chippewa Falls Waterworks is the main public water system for Chippewa Falls. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Apr 2023 – Oct 2023. 1 PFAS was detected.

ChemicalHighest resultDetected inEPA limit
PFBS
perfluorobutane sulfonic acid
4.8 ppt 1 of 4 samples —

Other water systems serving parts of Chippewa Falls

Water systemPFAS detectedHighest PFOA / PFOSTested
Village of Lake Hallie Waterworks
serves 10,000 people or fewer
None detected — Mar 2023 – Sep 2023

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Chippewa Falls

Chippewa Falls Waterworks reported 5,357 service lines (the pipes connecting homes to the water main) in its inventory. It reported no lead or galvanized lines requiring replacement.

0lead (0%)
0galvanized requiring replacement
0unknown material (0%)
5,357not lead (100%)

Other water systems serving parts of Chippewa Falls

Water systemService linesTotal
Village of Lake Hallie Waterworks0 lead · 0 galvanized · 0 unknown2,064

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Chippewa Falls drinking water violations

EPA records show no health-based violations for Chippewa Falls Waterworks since 2016. It also had 3 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Other water systems serving parts of Chippewa Falls

Water systemHealth-based violationsMonitoring/reporting
Village of Lake Hallie Waterworks1 (1 open)7

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Chippewa Falls

SiteTypeDistanceMedianSamplesYears
Chippewa River at Chippewa Falls Dam
Wisconsin Department of Natural Resources
River/Stream 0.2 mi44 mg/L272000–2006
CH-29/08W/33-0127
USGS Wisconsin Water Science Center
Well 1.4 mi122 mg/L12013
Lake Wissota - Little Lake Wissota Bay
Wisconsin Department of Natural Resources
Lake 4.5 mi26 mg/L12001
Lake Hallie - Center Of Lake - Deep Hole
Wisconsin Department of Natural Resources
Lake 4.8 mi61 mg/L22001–2002
Lake Wissota - 100' Bernhart's-Yellow River Bay
Wisconsin Department of Natural Resources
Lake 5.3 mi38 mg/L12001
Chippewa River - Beneath Nsp Dam
Wisconsin Department of Natural Resources
River/Stream 9.4 mi65 mg/L12000

Water hardness in towns near Chippewa Falls

TownDistanceMedianClass
Eau Claire10 mi 70 mg/LModerately hard
Menomonie26 mi 104 mg/LModerately hard
New Richmond58 mi 134 mg/LHard
River Falls61 mi 159 mg/LHard
Marshfield63 mi 209 mg/LVery hard
Hudson66 mi 96 mg/LModerately hard
Holmen67 mi 134 mg/LHard
Onalaska73 mi 185 mg/LVery hard
La Crosse77 mi 185 mg/LVery hard
Wausau85 mi 51 mg/LSoft

Chippewa County

Chippewa Falls is in Chippewa County, where the median is 36 mg/L (soft) across 12 sites.

See all of Chippewa County →

Wisconsin

The statewide median is 148 mg/L (hard) from 1,102 sites.

Wisconsin hardness map →

Chippewa Falls, WI water: common questions

Do I need a water softener in Chippewa Falls?

Probably not. Water measured around Chippewa Falls is 3.1 gpg (53 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable.When a softener helps →

Who supplies Chippewa Falls's drinking water?

The main public water system serving Chippewa Falls in EPA records is Chippewa Falls Waterworks. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Chippewa Falls?

It depends on what you want to remove. In Chippewa Falls, EPA testing found PFBS in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS. On the other hand, no lead service lines reported and no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next