Water hardness in St. Albans, WV
Water in St. Albans is moderately hard, with a median of 89 mg/L (5.2 grains per gallon) across Kanawha County.
There are not enough monitoring sites within 10 miles of St. Albans, so this page uses the Kanawha County median.
St. Albans tap water at a glance
- HardnessModerately hard (89 mg/L, 5.2 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
- PFASNone found in EPA's nationwide testing of the main water system.PFAS results →
- Lead pipesNo known lead lines; 5,636 lines are still of unknown material.Check your own pipe →
- Violations1 health-based violation since 2016.What they were →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 89 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 5.2 gpg (5 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for St. Albans
Prefilled with St. Albans's measured local hardness of 89 mg/L (5.2 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in St. Albans tap water
ST Albans Water is the main public water system for St. Albans. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Jul 2024 – Apr 2026. No PFAS were found at or above EPA's minimum reporting levels.
Other water systems serving parts of St. Albans
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| Wvawc-Kanawha Valley Dist serves over 10,000 people | None detected | — | Feb 2023 – Nov 2023 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in St. Albans
ST Albans Water reported 6,446 service lines (the pipes connecting homes to the water main) in its inventory. 0 are lead and 62 are galvanized lines that must be replaced, and 5,636 are still of unknown material.
EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask ST Albans Water whether your address is on its list.
Other water systems serving parts of St. Albans
| Water system | Service lines | Total |
|---|---|---|
| Wvawc-Kanawha Valley Dist | 0 lead · 162 galvanized · 85,540 unknown | 105,592 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
St. Albans drinking water violations
EPA records show 1 health-based violation for ST Albans Water since 2016, all since resolved or closed. The most recent began in Jul 2025. It also had 61 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.
| Contaminant or rule | Type | Violations | Most recent | Status |
|---|---|---|---|---|
| Total trihalomethanes (TTHM) byproducts formed when chlorine reacts with natural matter in water · what it means highest measured 85 UG/L; limit 0.080 mg/L | Contaminant above legal limit | 1 | Jul 2025 | Resolved/closed |
Other water systems serving parts of St. Albans
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| Wvawc-Kanawha Valley Dist | None | 3 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to St. Albans
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| Kan-0953 USGS West Virginia Water Science Center | Well | 8.1 mi | 44 mg/L | 1 | 2017 |
| Kan-0951 USGS West Virginia Water Science Center | Well | 8.7 mi | 74 mg/L | 1 | 2017 |
Water hardness in towns near St. Albans
| Town | Distance | Median | Class |
|---|---|---|---|
| South Charleston | 6 mi | 44 mg/L | Soft |
| Teays Valley | 7 mi | 64 mg/L | Moderately hard |
| Charleston | 10 mi | 89 mg/L | Moderately hard |
| Beckley | 55 mi | 78 mg/L | Moderately hard |
| Parkersburg | 63 mi | 122 mg/L | Hard |
| Vienna | 67 mi | 122 mg/L | Hard |
| Clarksburg | 100 mi | 345 mg/L | Very hard |
| Fairmont | 118 mi | 148 mg/L | Hard |
| Wheeling | 132 mi | 118 mg/L | Moderately hard |
| Morgantown | 133 mi | 492 mg/L | Very hard |
Kanawha County
St. Albans is in Kanawha County, where the median is 89 mg/L (moderately hard) across 6 sites.
See all of Kanawha County →West Virginia
The statewide median is 107 mg/L (moderately hard) from 416 sites.
West Virginia hardness map →St. Albans, WV water: common questions
Do I need a water softener in St. Albans?
Probably not. Water measured around St. Albans is 5.2 gpg (89 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable. If spotting bothers you, about 9,000 grains of capacity covers a 3-person home between weekly regenerations.Size it for your household →
Who supplies St. Albans's drinking water?
The main public water system serving St. Albans in EPA records is ST Albans Water. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →
Do I need a water filter in St. Albans?
It depends on what you want to remove. In St. Albans, the system had 1 health-based violation since 2016, for TTHM; the utility's annual report says what was done about it. On the other hand, no PFAS found in EPA testing and no lead service lines reported. A water softener is not a filter.How to read your water quality report →
Hardness scale
What to read next
- How to tell if your home has a lead pipe5,636 service lines here are of unknown material.
- TTHM in drinking waterDisinfection byproducts appear in this system's violation record.
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.