Water hardness in Pasco, WA

Water in Pasco is very hard, with a median of 278 mg/L (16.2 grains per gallon) across 12 monitoring sites within 10 miles.

276% harder than the Washington median (74 mg/L) 2nd hardest of 122 Washington towns Population 80,038
278mg/L
16.2 grains per gallon
Very hard

Pasco tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 278 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 16.2 gpg (15.6 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites12
Lab samples71
Sample years2000–2023
Middle 50% of sites170–316 mg/L
Groundwater (wells, springs)296 mg/L · 10 sites
Surface water (rivers, lakes)60 mg/L · 2 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Pasco

Prefilled with Pasco's measured local hardness of 278 mg/L (16.3 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Pasco tap water

Pasco Water Department is the main public water system for Pasco. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 8 samples taken Jul 2023 – Apr 2024. No PFAS were found at or above EPA's minimum reporting levels.

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Pasco

Pasco Water Department reported 23,800 service lines (the pipes connecting homes to the water main) in its inventory. It reported no known lead lines, but 10,550 lines are still of unknown material.

0lead (0%)
0galvanized requiring replacement
10,550unknown material (44%)
13,250not lead (56%)

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Pasco drinking water violations

EPA records show no health-based violations for Pasco Water Department since 2016. It also had 24 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Pasco

SiteTypeDistanceMedianSamplesYears
09N/30E-16D01 PN94
USGS Washington Water Science Center
Well 2.3 mi286 mg/L22002–2014
09N/29E-02G07 SU78
USGS Washington Water Science Center
Well 2.4 mi339 mg/L22002–2014
09N/30E-27L02 SU82
USGS Washington Water Science Center
Well 4.2 mi200 mg/L12002
SNAKE RIVER AT BURBANK, WA
USGS Washington Water Science Center
Stream 5.8 mi55 mg/L102000
10N/30E-07Q01 PN09
USGS Washington Water Science Center
Well 6.5 mi170 mg/L12002
10N/29E-17Q01 PN106
USGS Washington Water Science Center
Well 6.9 mi307 mg/L22002–2014

Water hardness in towns near Pasco

TownDistanceMedianClass
Kennewick5 mi 134 mg/LHard
Richland8 mi 220 mg/LVery hard
West Richland13 mi 87 mg/LModerately hard
Grandview38 mi 103 mg/LModerately hard
Walla Walla40 mi 58 mg/LSoft
Sunnyside42 mi 207 mg/LVery hard
Moses Lake60 mi 196 mg/LVery hard
Yakima72 mi 47 mg/LSoft
Ellensburg85 mi 44 mg/LSoft
East Wenatchee97 mi 67 mg/LModerately hard

Franklin County

Pasco is in Franklin County, where the median is 240 mg/L (very hard) across 29 sites.

See all of Franklin County →

Washington

The statewide median is 74 mg/L (moderately hard) from 890 sites.

Washington hardness map →

Pasco, WA water: common questions

Do I need a water softener in Pasco?

Very likely. Water measured around Pasco is 16.2 gpg (278 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 28,000 grains.Size it for your household →

Who supplies Pasco's drinking water?

The main public water system serving Pasco in EPA records is Pasco Water Department. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Pasco?

Not for anything in EPA's records: no PFAS found in EPA testing, no lead service lines reported and no health-based violations since 2016. People here who use a filter usually do it for taste, such as chlorine.Chlorine taste in tap water →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next