Water hardness in Des Moines, WA

Water in Des Moines is soft, with a median of 58 mg/L (3.4 grains per gallon) across 11 monitoring sites within 10 miles.

22% softer than the Washington median (74 mg/L) 75th hardest of 122 Washington towns Population 31,988
58mg/L
3.4 grains per gallon
Soft

Des Moines tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 58 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 3.4 gpg (3.2 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites11
Lab samples101
Sample years2000–2017
Middle 50% of sites39–84 mg/L
Groundwater (wells, springs)51 mg/L · 3 sites
Surface water (rivers, lakes)60 mg/L · 8 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Des Moines

Prefilled with Des Moines's measured local hardness of 58 mg/L (3.4 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Des Moines tap water

Des Moines is served by more than one water system. These systems supply ZIP codes in Des Moines and were tested for PFAS ("forever chemicals") in EPA's nationwide UCMR 5 study. Check your water bill to see which one is yours.

Water systems serving Des Moines

Water systemPFAS detectedHighest PFOA / PFOSTested
Highline Water District
serves over 10,000 people
None detected — Aug 2024 – May 2025
King County Water District #20
serves over 10,000 people
None detected — Mar 2024 – Dec 2024
Lakehaven Water and Sewer District
serves over 10,000 people
PFPeA, PFHxA, PFHxS +3 more ND / 4.1 ppt Jul 2024 – Mar 2025
City of Tacoma Water Division
serves over 10,000 people
PFHxS, PFBS — Jan 2025 – Oct 2025

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Des Moines

Des Moines is served by more than one water system. Their service line inventories, as reported to EPA:

Water systems serving Des Moines

Water systemService linesTotal
Highline Water District0 lead · 0 galvanized · 0 unknown18,780
King County Water District #200 lead · 141 galvanized · 0 unknown10,748
Lakehaven Water and Sewer District0 lead · 0 galvanized · 2,088 unknown34,089
City of Tacoma Water Division0 lead · 0 galvanized · 0 unknown114,107

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Des Moines drinking water violations

Des Moines is served by more than one water system. Health-based violations recorded by EPA since 2016:

Water systems serving Des Moines

Water systemHealth-based violationsMonitoring/reporting
Highline Water DistrictNone0
King County Water District #20None0
Lakehaven Water and Sewer DistrictNone1
City of Tacoma Water DivisionNone0

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Des Moines

SiteTypeDistanceMedianSamplesYears
MILL CREEK AT EARTHWORKS PARK AT KENT, WA
USGS Washington Water Science Center
Stream 4.3 mi96 mg/L102015
21N/04E-07R02 SWQA09
USGS Washington Water Science Center
Well 4.9 mi148 mg/L12016
MILL CREEK AT PEASLEY CANYON RD S NR AUBURN, WA
USGS Washington Water Science Center
Stream 6.4 mi76 mg/L102015
DUWAMISH RIVER AT GOLF COURSE AT TUKWILA, WA
USGS Washington Water Science Center
Stream 6.8 mi31 mg/L212000–2001
23N/05E-17F01
USGS Washington Water Science Center
Well 8.5 mi51 mg/L12016
23N/05E-17F04 SWQA13
USGS Washington Water Science Center
Well 8.6 mi48 mg/L12016

Water hardness in towns near Des Moines

TownDistanceMedianClass
SeaTac4 mi 77 mg/LModerately hard
Lakeland North4 mi 61 mg/LModerately hard
Kent5 mi 52 mg/LSoft
Federal Way5 mi 80 mg/LModerately hard
Burien6 mi 70 mg/LModerately hard
Tukwila6 mi 87 mg/LModerately hard
Vashon7 mi 64 mg/LModerately hard
Auburn8 mi 61 mg/LModerately hard
Lakeland South8 mi 61 mg/LModerately hard
Bryn Mawr-Skyway8 mi 87 mg/LModerately hard

King County

Des Moines is in King County, where the median is 61 mg/L (moderately hard) across 34 sites.

See all of King County →

Washington

The statewide median is 74 mg/L (moderately hard) from 890 sites.

Washington hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next