Water hardness in Arlington, VA

Water in Arlington is moderately hard, with a median of 67 mg/L (3.9 grains per gallon) across 23 monitoring sites within 10 miles.

76% harder than the Virginia median (38 mg/L) 28th hardest of 109 Virginia towns Population 207,627 (2010)
67mg/L
3.9 grains per gallon
Moderately hard

Large city utilities sometimes soften, blend or import water from distant reservoirs, so tap water in Arlington can differ from local source water. Your utility's annual Consumer Confidence Report lists the exact tap value.

Arlington tap water at a glance

  • HardnessModerately hard (67 mg/L, 3.9 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
  • PFAS2 found in EPA testing; every result with a federal limit was at or below it.PFAS results →
  • Lead pipesNo lead service lines reported.Details →
  • ViolationsNo health-based violations since 2016.EPA record →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 67 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 3.9 gpg (3.8 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites23
Lab samples1,076
Sample years2000–2026
Middle 50% of sites44–85 mg/L
Groundwater (wells, springs)44 mg/L · 3 sites
Surface water (rivers, lakes)68 mg/L · 20 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Arlington

Prefilled with Arlington's measured local hardness of 67 mg/L (3.9 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Arlington tap water

Arlington County is the main public water system for Arlington. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Feb 2024 – Nov 2024. 2 PFAS were detected.

ChemicalHighest resultDetected inEPA limit
PFPeA
perfluoropentanoic acid
4.5 ppt 2 of 4 samples —
PFHxA
perfluorohexanoic acid
3.3 ppt 1 of 4 samples —

Other water systems serving parts of Arlington

Water systemPFAS detectedHighest PFOA / PFOSTested
Fairfax County Water Authority
serves over 10,000 people
PFPeA, PFBA, PFHxA +5 more 7.4 / 5.7 ppt Mar 2024 – Feb 2025

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Arlington

Arlington County reported 37,117 service lines (the pipes connecting homes to the water main) in its inventory. It reported no lead or galvanized lines requiring replacement.

0lead (0%)
0galvanized requiring replacement
0unknown material (0%)
37,117not lead (100%)

Other water systems serving parts of Arlington

Water systemService linesTotal
Fairfax County Water Authority16 lead · 2 galvanized · 115 unknown290,219

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Arlington drinking water violations

EPA records show no health-based violations for Arlington County since 2016.

Other water systems serving parts of Arlington

Water systemHealth-based violationsMonitoring/reporting
Fairfax County Water AuthorityNone0

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Arlington

SiteTypeDistanceMedianSamplesYears
Rt. # 244 (Columbia Pike)
VIRGINIA DEPARTMENT OF ENVIRONMENTAL QUALITY
River/Stream 1.6 mi66 mg/L12001
Rt. # 120 (W. Glebe Rd)
VIRGINIA DEPARTMENT OF ENVIRONMENTAL QUALITY
River/Stream 2.7 mi116 mg/L522002–2026
Rt. # 120 (Glebe Rd)
VIRGINIA DEPARTMENT OF ENVIRONMENTAL QUALITY
River/Stream 3.6 mi86 mg/L312001–2026
POTOMAC RIVER AT CHAIN BRIDGE, AT WASHINGTON, DC
USGS Maryland Water Science Center
Stream 3.7 mi122 mg/L2932000–2023
BEAUREGARD STREET
VIRGINIA DEPARTMENT OF ENVIRONMENTAL QUALITY
River/Stream 4 mi45 mg/L12001
Pickett St. (off Holmes Run Pkwy @ park)
VIRGINIA DEPARTMENT OF ENVIRONMENTAL QUALITY
River/Stream 4.5 mi39 mg/L82001–2003

Water hardness in towns near Arlington

TownDistanceMedianClass
Bailey's Crossroads3 mi 57 mg/LSoft
Falls Church4 mi 62 mg/LModerately hard
Alexandria4 mi 49 mg/LSoft
Lincolnia5 mi 47 mg/LSoft
Idylwood6 mi 61 mg/LModerately hard
Annandale6 mi 53 mg/LSoft
Huntington6 mi 47 mg/LSoft
Rose Hill6 mi 47 mg/LSoft
McLean7 mi 62 mg/LModerately hard
Merrifield7 mi 60 mg/LModerately hard

Arlington County

Arlington is in Arlington County, where the median is 86 mg/L (moderately hard) across 3 sites.

See all of Arlington County →

Virginia

The statewide median is 38 mg/L (soft) from 2,622 sites.

Virginia hardness map →

Arlington, VA water: common questions

Do I need a water softener in Arlington?

Probably not. Water measured around Arlington is 3.9 gpg (67 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable. If spotting bothers you, about 7,000 grains of capacity covers a 3-person home between weekly regenerations.Size it for your household →

Who supplies Arlington's drinking water?

The main public water system serving Arlington in EPA records is Arlington County. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Arlington?

It depends on what you want to remove. In Arlington, EPA testing found PFPeA and PFHxA in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS. On the other hand, no lead service lines reported and no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next