Water hardness in Washington, UT
Water in Washington is very hard, with a median of 314 mg/L (18.4 grains per gallon) across 84 monitoring sites within 10 miles.
Washington tap water at a glance
- HardnessVery hard (314 mg/L, 18.4 gpg, local measurements). Water softeners are common at this level.Size a water softener →
- PFASNone found in EPA's nationwide testing of the main water system.PFAS results →
- Lead pipesNo lead service lines reported.Details →
- ViolationsNo health-based violations since 2016.EPA record →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 314 mg/L means at home
- Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
- Dishwasher: set the water hardness to about 18.4 gpg (17.6 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
- Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
- Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
- Water heater: flush the tank once a year to clear sediment and scale.
Size a softener for your home → Hard water and your water heater →
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Washington
Prefilled with Washington's measured local hardness of 314 mg/L (18.4 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Washington tap water
Washington City is the main public water system for Washington. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 6 samples taken Oct 2023 – Jul 2024. No PFAS were found at or above EPA's minimum reporting levels.
Other water systems serving parts of Washington
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| Hurricane City serves over 10,000 people | None detected | — | Mar 2025 – Dec 2025 |
| ST George City Water System serves over 10,000 people | None detected | — | Jan 2024 – Oct 2024 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Washington
Washington City reported 14,614 service lines (the pipes connecting homes to the water main) in its inventory. 0 are lead and 8 are galvanized lines that must be replaced.
EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask Washington City whether your address is on its list.
Other water systems serving parts of Washington
| Water system | Service lines | Total |
|---|---|---|
| Hurricane City | 0 lead · 0 galvanized · 0 unknown | 11,594 |
| ST George City Water System | 0 lead · 0 galvanized · 0 unknown | 44,972 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Washington drinking water violations
EPA records show no health-based violations for Washington City since 2016. It also had 15 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.
Other water systems serving parts of Washington
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| Hurricane City | None | 11 |
| ST George City Water System | None | 10 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Washington
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| (C-42-15)11dcb- 1 USGS Utah Water Science Center | Well | 1.5 mi | 543 mg/L | 1 | 2005 |
| (C-42-15)14bbc-S1 USGS Utah Water Science Center | Spring | 1.6 mi | 258 mg/L | 1 | 2004 |
| MILL CK AB 1-15 XING (WASHINGTON) Utah Department Of Environmental Quality | River/Stream | 1.8 mi | 361 mg/L | 1 | 2006 |
| (C-42-15)15bbd-S1 USGS Utah Water Science Center | Spring | 2.4 mi | 426 mg/L | 1 | 2003 |
| (C-42-15)10bcd- 1 USGS Utah Water Science Center | Well | 2.7 mi | 344 mg/L | 1 | 2005 |
| (C-42-15)27cdd Drain 2A nr. Washington USGS Utah Water Science Center | Stream: Ditch | 2.9 mi | 1720 mg/L | 1 | 2010 |
Water hardness in towns near Washington
| Town | Distance | Median | Class |
|---|---|---|---|
| St. George | 6 mi | 618 mg/L | Very hard |
| Hurricane | 7 mi | 278 mg/L | Very hard |
| Ivins | 11 mi | 258 mg/L | Very hard |
| Cedar City | 44 mi | 494 mg/L | Very hard |
| Santaquin | 217 mi | 334 mg/L | Very hard |
| Payson | 222 mi | 299 mg/L | Very hard |
| Salem | 225 mi | 289 mg/L | Very hard |
| Spanish Fork | 229 mi | 294 mg/L | Very hard |
| Mapleton | 231 mi | 288 mg/L | Very hard |
| Springville | 233 mi | 292 mg/L | Very hard |
Washington County
Washington is in Washington County, where the median is 247 mg/L (very hard) across 170 sites.
See all of Washington County →Washington, UT water: common questions
Do I need a water softener in Washington?
Very likely. Water measured around Washington is 18.4 gpg (314 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 32,000 grains.Size it for your household →
Who supplies Washington's drinking water?
The main public water system serving Washington in EPA records is Washington City. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →
Do I need a water filter in Washington?
Not for anything in EPA's records: no PFAS found in EPA testing, no lead service lines reported and no health-based violations since 2016. People here who use a filter usually do it for taste, such as chlorine.Chlorine taste in tap water →
Hardness scale
What to read next
- Do you need a water softener?Water here is very hard; size a softener with our calculator.
- Hard water and your water heaterHow scale affects your water heater and how often to flush.
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.