Water hardness in Sevier County, UT
Water in Sevier County is moderately hard, with a median of 108 mg/L (6.3 grains per gallon) across 86 monitoring sites.
Sevier County water at a glance
- HardnessModerately hard (108 mg/L, 6.3 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 108 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 6.3 gpg (6.1 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Sevier County
Prefilled with Sevier County's measured local hardness of 108 mg/L (6.3 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Sevier County on the Utah map
Cities and communities in Sevier County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Richfield | 364 | Very hard | 10 sites within 10 miles |
| Monroe | 93 | Moderately hard | 12 sites within 10 miles |
| Salina | 296 | Very hard | 8 sites within 10 miles |
| Aurora | 305 | Very hard | 10 sites within 10 miles |
| Annabella | 319 | Very hard | 11 sites within 10 miles |
| Elsinore | 305 | Very hard | 10 sites within 10 miles |
| Redmond | 365 | Very hard | 7 sites within 10 miles |
| Central Valley | 315 | Very hard | 10 sites within 10 miles |
| Glenwood | 319 | Very hard | 13 sites within 10 miles |
| Sigurd | 365 | Very hard | 13 sites within 10 miles |
| Koosharem | 77 | Moderately hard | 24 sites within 10 miles |
| Joseph | 101 | Moderately hard | 9 sites within 10 miles |
Water quality in Sevier County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Richfield | Richfield City | None detected | 0 lead · 1,427 unknown | None |
| Monroe | Monroe City | Not tested | 0 lead · 472 unknown | None |
| Salina | Salina City Water System | Not tested | 0 lead · 335 unknown | None |
| Aurora | Aurora City | Not tested | 0 lead · 0 unknown | None |
| Annabella | Annabella Town Water System | Not tested | 0 lead · 106 unknown | 1 |
| Elsinore | Elsinore Town Water System | Not tested | 0 lead · 357 unknown | None |
| Redmond | Redmond Town Water System | Not tested | 0 lead · 185 unknown | None |
| Central Valley | Central Valley Town | Not tested | 0 lead · 80 unknown | None |
| Glenwood | Glenwood Town Water System | Not tested | 0 lead · 82 unknown | 3 (1 open) |
| Sigurd | Sigurd Town Water System | Not tested | 0 lead · 117 unknown | None |
| Koosharem | Koosharem | Not tested | 0 lead · 141 unknown | 1 |
| Joseph | Joseph Town | Not tested | 0 lead · 24 unknown | 1 |
Neighboring counties
- Piute County129 mg/L
- Sanpete County296 mg/L
- Wayne County297 mg/L
- Emery County619 mg/L
- Garfield County187 mg/L
- Millard County302 mg/L
Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.