Water hardness in Sandy, UT

Water in Sandy is very hard, with a median of 349 mg/L (20.4 grains per gallon) across 152 monitoring sites within 10 miles.

36% harder than the Utah median (256 mg/L) 19th hardest of 67 Utah towns Population 91,943
349mg/L
20.4 grains per gallon
Very hard

Sandy tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 349 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 20.4 gpg (19.6 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites152
Lab samples1,790
Sample years2000–2023
Middle 50% of sites220–488 mg/L
Groundwater (wells, springs)366 mg/L · 105 sites
Surface water (rivers, lakes)314 mg/L · 47 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Sandy

Prefilled with Sandy's measured local hardness of 349 mg/L (20.4 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Sandy tap water

Sandy City Water System is the main public water system for Sandy. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 12 samples taken Jul 2023 – Jul 2025. No PFAS were found at or above EPA's minimum reporting levels.

Other water systems serving parts of Sandy

Water systemPFAS detectedHighest PFOA / PFOSTested
Jordan Valley WCD
serves over 10,000 people
None detected — Aug 2023 – May 2025
Salt Lake City Water System
serves over 10,000 people
PFHxS, PFOS, PFPeA +1 more ND / 7.1 ppt Oct 2023 – Oct 2024
White City Wid
serves over 10,000 people
None detected — Feb 2025 – Aug 2025
Waterpro INC
serves over 10,000 people
None detected — Mar 2023 – Dec 2023
Draper City Water System
serves over 10,000 people
None detected — Mar 2024 – Dec 2024

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Sandy

Sandy City Water System reported 26,213 service lines (the pipes connecting homes to the water main) in its inventory. It reported no lead or galvanized lines requiring replacement.

0lead (0%)
0galvanized requiring replacement
0unknown material (0%)
26,213not lead (100%)

Other water systems serving parts of Sandy

Water systemService linesTotal
Jordan Valley WCD0 lead · 0 galvanized · 0 unknown8,578
Salt Lake City Water System120 lead · 102 galvanized · 31,866 unknown86,123
White City Wid0 lead · 0 galvanized · 1,607 unknown4,222
Waterpro INC0 lead · 0 galvanized · 0 unknown8,662
Draper City Water System0 lead · 0 galvanized · 0 unknown4,605

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Sandy drinking water violations

EPA records show 1 health-based violation for Sandy City Water System since 2016, all since resolved or closed. The most recent began in Feb 2019. It also had 133 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Contaminant or ruleTypeViolationsMost recentStatus
Fluoride
naturally occurring or added; above the federal limit
highest measured 104 MG/L; limit 4.0 mg/L
Contaminant above legal limit 1 Feb 2019 Resolved/closed

Other water systems serving parts of Sandy

Water systemHealth-based violationsMonitoring/reporting
Jordan Valley WCDNone2
Salt Lake City Water System14
White City WidNone5
Waterpro INCNone78
Draper City Water SystemNone1

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Sandy

SiteTypeDistanceMedianSamplesYears
(D- 3- 1) 8bdd- 1
USGS Utah Water Science Center
Well 0.7 mi472 mg/L22008–2021
(D- 3- 1)17abb- 2
USGS Utah Water Science Center
Well 0.7 mi279 mg/L12001
(D- 3- 1)16ccb- 1
USGS Utah Water Science Center
Well 1.2 mi366 mg/L22012–2020
(D- 3- 1) 3cdc- 1
USGS Utah Water Science Center
Well 1.3 mi153 mg/L12001
(D- 3- 1) 5aca- 2
USGS Utah Water Science Center
Well 1.3 mi134 mg/L12000
(D- 3- 1) 5aca- 1 LUS32
USGS Utah Water Science Center
Well 1.3 mi316 mg/L132000–2020

Water hardness in towns near Sandy

TownDistanceMedianClass
Cottonwood Heights3 mi 346 mg/LVery hard
Midvale4 mi 364 mg/LVery hard
Draper5 mi 316 mg/LVery hard
Murray6 mi 356 mg/LVery hard
Holladay6 mi 351 mg/LVery hard
South Jordan7 mi 404 mg/LVery hard
Riverton7 mi 414 mg/LVery hard
Taylorsville8 mi 370 mg/LVery hard
Millcreek8 mi 344 mg/LVery hard
Bluffdale8 mi 366 mg/LVery hard

Salt Lake County

Sandy is in Salt Lake County, where the median is 369 mg/L (very hard) across 381 sites.

See all of Salt Lake County →

Utah

The statewide median is 256 mg/L (very hard) from 4,077 sites.

Utah hardness map →

Sandy, UT water: common questions

Do I need a water softener in Sandy?

Very likely. Water measured around Sandy is 20.4 gpg (349 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 36,000 grains.Size it for your household →

Who supplies Sandy's drinking water?

The main public water system serving Sandy in EPA records is Sandy City Water System. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Sandy?

It depends on what you want to remove. In Sandy, the system had 1 health-based violation since 2016, for Fluoride; the utility's annual report says what was done about it. On the other hand, no PFAS found in EPA testing and no lead service lines reported. A water softener is not a filter.How to read your water quality report →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next