Water hardness in Sugar Land, TX

Water in Sugar Land is hard, with a median of 167 mg/L (9.8 grains per gallon) across 37 monitoring sites within 10 miles.

14% softer than the Texas median (194 mg/L) 131st hardest of 251 Texas towns Population 108,515
167mg/L
9.8 grains per gallon
Hard

Large city utilities sometimes soften, blend or import water from distant reservoirs, so tap water in Sugar Land can differ from local source water. Your utility's annual Consumer Confidence Report lists the exact tap value.

Sugar Land tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 167 mg/L means at home

  • Water softener: Many households here choose a softener to protect water heaters and appliances from scale.
  • Dishwasher: set the water hardness to about 9.8 gpg (9.4 °dH), which is a medium-to-high hardness setting, with rinse aid.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites37
Lab samples57
Sample years2000–2015
Middle 50% of sites140–186 mg/L
Groundwater (wells, springs)166 mg/L · 35 sites
Surface water (rivers, lakes)174 mg/L · 2 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Sugar Land

Prefilled with Sugar Land's measured local hardness of 167 mg/L (9.8 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Sugar Land tap water

City of Sugar Land is the main public water system for Sugar Land. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 22 samples taken Feb 2023 – Nov 2023. 8 PFAS were detected. The highest PFOA result was above EPA's drinking water limit (4 ppt).

ChemicalHighest resultDetected inEPA limit
6:2 FTS
6:2 fluorotelomer sulfonic acid
672 ppt 2 of 22 samples —
PFPeA
perfluoropentanoic acid
358 ppt 16 of 22 samples —
PFBA
perfluorobutanoic acid
74.8 ppt 5 of 22 samples —
PFHxA
perfluorohexanoic acid
12.9 ppt 6 of 22 samples —
PFBS
perfluorobutane sulfonic acid
5.8 ppt 5 of 22 samples —
PFOA
perfluorooctanoic acid
4.1 ppt 2 of 22 samples 4 ppt
PFHpA
perfluoroheptanoic acid
3.6 ppt 2 of 22 samples —
ADONA 3.4 ppt 2 of 22 samples —

Other water systems serving parts of Sugar Land

Water systemPFAS detectedHighest PFOA / PFOSTested
City of Sugar Land - Greatwood
serves over 10,000 people
None detected — Mar 2023 – Sep 2023
City of Houston
serves over 10,000 people
6:2 FTS, PFBA, PFPeA +1 more — Feb 2023 – Feb 2025
City of Rosenberg
serves over 10,000 people
PFPeA, PFBA, PFHxA +1 more — Nov 2024 – Aug 2025
Fort Bend County Wcid 2
serves over 10,000 people
PFPeA, PFBA, PFHxA +1 more — Mar 2025 – Dec 2025
City of Richmond
serves over 10,000 people
PFPeA, PFBA, PFBS +1 more — Jul 2024 – Jun 2025

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Sugar Land

City of Sugar Land reported 25,545 service lines (the pipes connecting homes to the water main) in its inventory. 0 are lead and 110 are galvanized lines that must be replaced.

0lead (0%)
110galvanized requiring replacement
0unknown material (0%)
25,435not lead (100%)

EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask City of Sugar Land whether your address is on its list.

Other water systems serving parts of Sugar Land

Water systemService linesTotal
City of Sugar Land - Greatwood0 lead · 0 galvanized · 0 unknown4,150
City of Houston0 lead · 0 galvanized · 427,111 unknown508,198
City of Rosenberg0 lead · 1,614 galvanized · 0 unknown12,463
Fort Bend County Wcid 20 lead · 0 galvanized · 0 unknown6,829
City of Richmond0 lead · 187 galvanized · 1 unknown7,576

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Sugar Land drinking water violations

EPA records show no health-based violations for City of Sugar Land since 2016. It also had 1 monitoring or reporting violation (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Other water systems serving parts of Sugar Land

Water systemHealth-based violationsMonitoring/reporting
City of Sugar Land - GreatwoodNone0
City of Houston11
City of RosenbergNone18
Fort Bend County Wcid 2None2
City of RichmondNone4

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Sugar Land

SiteTypeDistanceMedianSamplesYears
LJ-65-20-706
USGS Texas Water Science Center
Well 5.5 mi183 mg/L12014
LJ-65-20-414
USGS Texas Water Science Center
Well 5.8 mi151 mg/L12010
LJ-65-20-814
USGS Texas Water Science Center
Well 5.9 mi234 mg/L12014
LJ-65-20-813
USGS Texas Water Science Center
Well 5.9 mi97 mg/L12014
LJ-65-20-811
USGS Texas Water Science Center
Well 5.9 mi157 mg/L12010
LJ-65-20-417
USGS Texas Water Science Center
Well 5.9 mi186 mg/L12014

Water hardness in towns near Sugar Land

TownDistanceMedianClass
Stafford5 mi 154 mg/LHard
Four Corners6 mi 161 mg/LHard
Missouri City6 mi 157 mg/LHard
Pecan Grove6 mi 180 mg/LHard
Mission Bend7 mi 158 mg/LHard
Richmond8 mi 180 mg/LHard
Fresno11 mi 151 mg/LHard
Rosenberg12 mi 167 mg/LHard
Cinco Ranch13 mi 170 mg/LHard
Bellaire13 mi 154 mg/LHard

Fort Bend County

Sugar Land is in Fort Bend County, where the median is 156 mg/L (hard) across 11 sites.

See all of Fort Bend County →

Texas

The statewide median is 194 mg/L (very hard) from 2,271 sites.

Texas hardness map →

Sugar Land, TX water: common questions

Do I need a water softener in Sugar Land?

Many homes here use one. Water measured around Sugar Land is 9.8 gpg (167 mg/L, measured locally), above the 7 gpg (120 mg/L) level where scale on fixtures, appliances and water heaters becomes noticeable. For a 3-person home that regenerates weekly, that means a softener of about 17,000 grains.Size it for your household →

Who supplies Sugar Land's drinking water?

The main public water system serving Sugar Land in EPA records is City of Sugar Land. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Sugar Land?

It depends on what you want to remove. In Sugar Land, EPA testing found 6:2 FTS, PFPeA and PFBA and 5 other PFAS in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS. On the other hand, no lead service lines reported and no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next