Water hardness in Port Arthur, TX

Water in Port Arthur is very hard, with a median of 260 mg/L (15.2 grains per gallon) across 5 monitoring sites within 10 miles.

34% harder than the Texas median (194 mg/L) 64th hardest of 251 Texas towns Population 55,547
260mg/L
15.2 grains per gallon
Very hard

Port Arthur tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 260 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 15.2 gpg (14.6 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites5
Lab samples17
Sample years2001–2005
Middle 50% of sites103–792 mg/L
Groundwater (wells, springs)101 mg/L · 1 sites
Surface water (rivers, lakes)526 mg/L · 4 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Port Arthur

Prefilled with Port Arthur's measured local hardness of 260 mg/L (15.2 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Port Arthur tap water

City of Port Arthur is the main public water system for Port Arthur. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 3 samples taken Oct 2023 – Apr 2024. 1 PFAS was detected.

ChemicalHighest resultDetected inEPA limit
PFBA
perfluorobutanoic acid
5.5 ppt 1 of 3 samples —

Other water systems serving parts of Port Arthur

Water systemPFAS detectedHighest PFOA / PFOSTested
City of Beaumont Water Utility Dept
serves over 10,000 people
None detected — Jan 2023 – Oct 2023
City of Nederland
serves over 10,000 people
None detected — Mar 2025 – Jan 2026
City of Groves
serves over 10,000 people
None detected — Oct 2023 – Oct 2025
City of Orange
serves over 10,000 people
None detected — Mar 2023 – Aug 2024

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Port Arthur

City of Port Arthur reported 18,983 service lines (the pipes connecting homes to the water main) in its inventory. 22 are lead and 111 are galvanized lines that must be replaced, and 14,271 are still of unknown material.

22lead (<1%)
111galvanized requiring replacement
14,271unknown material (75%)
4,579not lead (24%)

EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask City of Port Arthur whether your address is on its list.

Other water systems serving parts of Port Arthur

Water systemService linesTotal
City of Beaumont Water Utility Dept1 lead · 102 galvanized · 41,727 unknown49,004
City of Nederland0 lead · 0 galvanized · 735 unknown879
City of GrovesNot reported—
City of Orange1 lead · 729 galvanized · 0 unknown7,687

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Port Arthur drinking water violations

EPA records show 2 health-based violations for City of Port Arthur since 2016, all since resolved or closed. The most recent began in Jan 2025. It also had 4 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Contaminant or ruleTypeViolationsMost recentStatus
Surface water treatment (filtration/turbidity)
filtration requirements that protect against microbes such as Cryptosporidium
Treatment requirement not met 2 Jan 2025 Resolved/closed

Other water systems serving parts of Port Arthur

Water systemHealth-based violationsMonitoring/reporting
City of Beaumont Water Utility DeptNone1
City of Nederland107
City of Groves3 (1 open)3
City of Orange119

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Port Arthur

SiteTypeDistanceMedianSamplesYears
ALLIGATOR BAYOU AT SH82
Texas Commission on Environmental Quality
River/Stream 5.3 mi103 mg/L122004–2005
STAR LAKE CANAL ABOVE NECHES R
Texas Commission on Environmental Quality
Canal Drainage 5.5 mi260 mg/L12001
NECHES RIVER AT SH 87
Texas Commission on Environmental Quality
River/Stream 5.7 mi1440 mg/L22001
NECHES RIVER AT CITY PARK
Texas Commission on Environmental Quality
River/Stream 7.5 mi792 mg/L12001
UJ-62-58-810
USGS Texas Water Science Center
Well 9.8 mi101 mg/L12005

Water hardness in towns near Port Arthur

TownDistanceMedianClass
Groves3 mi 260 mg/LVery hard
Port Neches6 mi 260 mg/LVery hard
Nederland8 mi 182 mg/LVery hard
Orange18 mi 60 mg/LSoft
Beaumont20 mi 49 mg/LSoft
Lumberton31 mi 29 mg/LSoft
Baytown65 mi 620 mg/LVery hard
Texas City68 mi 300 mg/LVery hard
Seabrook69 mi 532 mg/LVery hard
La Porte71 mi 750 mg/LVery hard

Orange County

Port Arthur is in Orange County, where the median is 46 mg/L (soft) across 16 sites.

See all of Orange County →

Texas

The statewide median is 194 mg/L (very hard) from 2,271 sites.

Texas hardness map →

Port Arthur, TX water: common questions

Do I need a water softener in Port Arthur?

Very likely. Water measured around Port Arthur is 15.2 gpg (260 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 27,000 grains.Size it for your household →

Who supplies Port Arthur's drinking water?

The main public water system serving Port Arthur in EPA records is City of Port Arthur. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Port Arthur?

It depends on what you want to remove. In Port Arthur, EPA testing found PFBA in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS; the system reports 22 lead service lines; if your home has one, a filter certified to remove lead is the usual step until the line is replaced; the system had 2 health-based violations since 2016, for the Interim Enhanced Surface Water Treatment Rule; the utility's annual report says what was done about them. A water softener is not a filter.Filters that remove PFAS →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next