Water hardness in Alice, TX

Water in Alice is hard, with a median of 180 mg/L (10.5 grains per gallon) across Jim Wells County.

about the same as the Texas median (194 mg/L) 120th hardest of 251 Texas towns Population 17,579
180mg/L
10.5 grains per gallon
Hard

There are not enough monitoring sites within 10 miles of Alice, so this page uses the Jim Wells County median.

Alice tap water at a glance

  • HardnessHard (180 mg/L, 10.5 gpg, local measurements). Scale on fixtures, kettles and water heaters is likely.Size a water softener →
  • PFAS1 found in EPA testing; every result with a federal limit was at or below it.PFAS results →
  • Lead pipesNo lead service lines reported.Details →
  • ViolationsNo health-based violations since 2016.EPA record →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 180 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 10.5 gpg (10.1 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites3
Lab samples93
Sample years2000–2013
Middle 50% of sites150–191 mg/L
Groundwater (wells, springs)121 mg/L · 1 sites
Surface water (rivers, lakes)191 mg/L · 2 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Alice

Prefilled with Alice's measured local hardness of 180 mg/L (10.5 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Alice tap water

City of Alice is the main public water system for Alice. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Feb 2024 – Nov 2024. 1 PFAS was detected.

ChemicalHighest resultDetected inEPA limit
PFBA
perfluorobutanoic acid
11.4 ppt 4 of 4 samples —

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Alice

City of Alice reported 7,327 service lines (the pipes connecting homes to the water main) in its inventory. It reported no lead or galvanized lines requiring replacement.

0lead (0%)
0galvanized requiring replacement
0unknown material (0%)
7,327not lead (100%)

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Alice drinking water violations

EPA records show no health-based violations for City of Alice since 2016.

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Water hardness in towns near Alice

TownDistanceMedianClass
Robstown24 mi 48 mg/LSoft
Beeville49 mi 476 mg/LVery hard
Ingleside53 mi 48 mg/LSoft
Corpus Christi55 mi 48 mg/LSoft
Rockport65 mi 218 mg/LVery hard
Pleasanton88 mi 183 mg/LVery hard
Laredo88 mi 245 mg/LVery hard
Victoria99 mi 301 mg/LVery hard
Edinburg99 mi 232 mg/LVery hard
Alton103 mi 232 mg/LVery hard

Jim Wells County

Alice is in Jim Wells County, where the median is 180 mg/L (hard) across 3 sites.

See all of Jim Wells County →

Texas

The statewide median is 194 mg/L (very hard) from 2,271 sites.

Texas hardness map →

Alice, TX water: common questions

Do I need a water softener in Alice?

Many homes here use one. Water measured around Alice is 10.5 gpg (180 mg/L, measured locally), above the 7 gpg (120 mg/L) level where scale on fixtures, appliances and water heaters becomes noticeable. For a 3-person home that regenerates weekly, that means a softener of about 19,000 grains.Size it for your household →

Who supplies Alice's drinking water?

The main public water system serving Alice in EPA records is City of Alice. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Alice?

It depends on what you want to remove. In Alice, EPA testing found PFBA in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS. On the other hand, no lead service lines reported and no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next