Water hardness in Mitchell, SD

Water in Mitchell is very hard, with a median of 540 mg/L (31.6 grains per gallon) across Davison County.

32% harder than the South Dakota median (410 mg/L) 4th hardest of 13 South Dakota towns Population 15,621
540mg/L
31.6 grains per gallon
Very hard

There are not enough monitoring sites within 10 miles of Mitchell, so this page uses the Davison County median.

Mitchell tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 540 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 31.6 gpg (30.3 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites3
Lab samples64
Sample years2000–2014
Middle 50% of sites526–930 mg/L
Groundwater (wells, springs)1320 mg/L · 1 sites
Surface water (rivers, lakes)526 mg/L · 2 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Mitchell

Prefilled with Mitchell's measured local hardness of 540 mg/L (31.6 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Mitchell tap water

The City of Mitchell water system is the main public water system for Mitchell. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken May 2024 – Feb 2025. No PFAS were found at or above EPA's minimum reporting levels.

Other water systems serving parts of Mitchell

Water systemPFAS detectedHighest PFOA / PFOSTested
Bon Homme-Yankton RWS
serves over 10,000 people
None detected — Sep 2023 – Jun 2024

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Mitchell

The City of Mitchell water system reported 6,064 service lines (the pipes connecting homes to the water main) in its inventory. 219 are lead and 0 are galvanized lines that must be replaced, and 2,494 are still of unknown material.

219lead (4%)
0galvanized requiring replacement
2,494unknown material (41%)
3,351not lead (55%)

EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask the City of Mitchell water system whether your address is on its list.

Other water systems serving parts of Mitchell

Water systemService linesTotal
BY Water District0 lead · 0 galvanized · 0 unknown5,245

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Mitchell drinking water violations

EPA records show no health-based violations for the City of Mitchell water system since 2016. It also had 1 monitoring or reporting violation (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Other water systems serving parts of Mitchell

Water systemHealth-based violationsMonitoring/reporting
Bon Homme-Yankton RWS20

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Mitchell

SiteTypeDistanceMedianSamplesYears
WQM 37
South Dakota Department of Environment and Natural Resources (State)
River/Stream 4.1 mi511 mg/L332000–2014
WQM 7
South Dakota Department of Environment and Natural Resources (State)
River/Stream 7.8 mi496 mg/L332000–2014

Water hardness in towns near Mitchell

TownDistanceMedianClass
Huron45 mi 510 mg/LVery hard
Yankton66 mi 415 mg/LVery hard
Sioux Falls67 mi 250 mg/LVery hard
Brandon73 mi 480 mg/LVery hard
Brookings74 mi 491 mg/LVery hard
Vermillion86 mi 828 mg/LVery hard
Watertown93 mi 379 mg/LVery hard
Pierre122 mi 280 mg/LVery hard
Aberdeen122 mi 450 mg/LVery hard
Box Elder252 mi 576 mg/LVery hard

Davison County

Mitchell is in Davison County, where the median is 540 mg/L (very hard) across 3 sites.

See all of Davison County →

South Dakota

The statewide median is 410 mg/L (very hard) from 498 sites.

South Dakota hardness map →

Mitchell, SD water: common questions

Do I need a water softener in Mitchell?

Very likely. Water measured around Mitchell is 31.6 gpg (540 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 55,000 grains.Size it for your household →

Who supplies Mitchell's drinking water?

The main public water system serving Mitchell in EPA records is Mitchell. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Mitchell?

It depends on what you want to remove. In Mitchell, the system reports 219 lead service lines; if your home has one, a filter certified to remove lead is the usual step until the line is replaced. On the other hand, no PFAS found in EPA testing and no health-based violations since 2016. A water softener is not a filter.Check your own service line →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next