Water hardness in Wilsonville, OR

Water in Wilsonville is moderately hard, with a median of 66 mg/L (3.9 grains per gallon) across 53 monitoring sites within 10 miles.

about the same as the Oregon median (71 mg/L) 30th hardest of 67 Oregon towns Population 26,345
66mg/L
3.9 grains per gallon
Moderately hard

Wilsonville tap water at a glance

  • HardnessModerately hard (66 mg/L, 3.9 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
  • PFASNone found in EPA's nationwide testing of the main water system.PFAS results →
  • Lead pipesNo lead service lines reported.Details →
  • ViolationsNo health-based violations since 2016.EPA record →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 66 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 3.9 gpg (3.7 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites53
Lab samples768
Sample years2000–2025
Middle 50% of sites37–90 mg/L
Groundwater (wells, springs)104 mg/L · 18 sites
Surface water (rivers, lakes)48 mg/L · 35 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Wilsonville

Prefilled with Wilsonville's measured local hardness of 66 mg/L (3.9 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Wilsonville tap water

City of Wilsonville is the main public water system for Wilsonville. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Dec 2024 – Sep 2025. No PFAS were found at or above EPA's minimum reporting levels.

Other water systems serving parts of Wilsonville

Water systemPFAS detectedHighest PFOA / PFOSTested
City of Sherwood
serves over 10,000 people
6:2 FTS, 8:2 FTS — Sep 2024 – Jun 2025
City of Tigard
serves over 10,000 people
None detected — Apr 2024 – Oct 2025
City of Tualatin
serves over 10,000 people
None detected — Jan 2024 – Oct 2024

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Wilsonville

City of Wilsonville reported 7,310 service lines (the pipes connecting homes to the water main) in its inventory. It reported no lead or galvanized lines requiring replacement.

0lead (0%)
0galvanized requiring replacement
0unknown material (0%)
7,310not lead (100%)

Other water systems serving parts of Wilsonville

Water systemService linesTotal
City of Sherwood0 lead · 0 galvanized · 222 unknown6,268
City of Tigard0 lead · 0 galvanized · 0 unknown21,751
City of Tualatin0 lead · 0 galvanized · 0 unknown7,020

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Wilsonville drinking water violations

EPA records show no health-based violations for City of Wilsonville since 2016. It also had 10 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Other water systems serving parts of Wilsonville

Water systemHealth-based violationsMonitoring/reporting
City of SherwoodNone3
City of TigardNone14
City of TualatinNone6

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Wilsonville

SiteTypeDistanceMedianSamplesYears
Mid Willamette Groundwater Study Well MWV-050
Department of Environmental Quality - State of Oregon
Well 2.1 mi73 mg/L12017
Mid Willamette Groundwater Study Well MWV-052
Department of Environmental Quality - State of Oregon
Well 2.3 mi84 mg/L12017
Molalla River at River Mile 0.2
Department of Environmental Quality - State of Oregon
River/Stream 2.7 mi37 mg/L32004–2005
Willamette River at Canby Ferry
Department of Environmental Quality - State of Oregon
River/Stream 3.9 mi24 mg/L462000–2024
Mid Willamette Groundwater Study Well MWV-051
Department of Environmental Quality - State of Oregon
Well 4.2 mi73 mg/L12017
Molalla River at Knights Bridge Road (Canby)
Department of Environmental Quality - State of Oregon
River/Stream 4.2 mi20 mg/L522000–2024

Water hardness in towns near Wilsonville

TownDistanceMedianClass
Tualatin5 mi 61 mg/LModerately hard
Sherwood5 mi 64 mg/LModerately hard
Canby5 mi 67 mg/LModerately hard
West Linn7 mi 56 mg/LSoft
Tigard8 mi 60 mg/LModerately hard
Lake Oswego8 mi 57 mg/LSoft
Oregon City9 mi 56 mg/LSoft
Newberg9 mi 99 mg/LModerately hard
Oak Grove10 mi 54 mg/LSoft
Gladstone10 mi 54 mg/LSoft

Washington County

Wilsonville is in Washington County, where the median is 68 mg/L (moderately hard) across 28 sites.

See all of Washington County →

Oregon

The statewide median is 71 mg/L (moderately hard) from 2,142 sites.

Oregon hardness map →

Wilsonville, OR water: common questions

Do I need a water softener in Wilsonville?

Probably not. Water measured around Wilsonville is 3.9 gpg (66 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable. If spotting bothers you, about 7,000 grains of capacity covers a 3-person home between weekly regenerations.Size it for your household →

Who supplies Wilsonville's drinking water?

The main public water system serving Wilsonville in EPA records is City of Wilsonville. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Wilsonville?

Not for anything in EPA's records: no PFAS found in EPA testing, no lead service lines reported and no health-based violations since 2016. People here who use a filter usually do it for taste, such as chlorine.Chlorine taste in tap water →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next