Water hardness in Sweet Home, OR

Water in Sweet Home is moderately hard, with a median of 117 mg/L (6.8 grains per gallon) across Linn County.

65% harder than the Oregon median (71 mg/L) 11th hardest of 67 Oregon towns Population 10,206
117mg/L
6.8 grains per gallon
Moderately hard

There are not enough monitoring sites within 10 miles of Sweet Home, so this page uses the Linn County median.

Sweet Home tap water at a glance

  • HardnessModerately hard (117 mg/L, 6.8 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
  • PFASNone found in EPA's nationwide testing of the main water system.PFAS results →
  • Lead pipesNo lead service lines reported.Details →
  • ViolationsNo health-based violations since 2016.EPA record →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 117 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 6.8 gpg (6.6 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites67
Lab samples404
Sample years2000–2024
Middle 50% of sites51–157 mg/L
Groundwater (wells, springs)138 mg/L · 49 sites
Surface water (rivers, lakes)24 mg/L · 18 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Sweet Home

Prefilled with Sweet Home's measured local hardness of 117 mg/L (6.8 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Sweet Home tap water

City of Sweet Home is the main public water system for Sweet Home. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Mar 2024 – Jan 2025. No PFAS were found at or above EPA's minimum reporting levels.

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Sweet Home

City of Sweet Home reported 2,788 service lines (the pipes connecting homes to the water main) in its inventory. It reported no lead or galvanized lines requiring replacement.

0lead (0%)
0galvanized requiring replacement
0unknown material (0%)
2,788not lead (100%)

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Sweet Home drinking water violations

EPA records show no health-based violations for City of Sweet Home since 2016. It also had 19 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Sweet Home

SiteTypeDistanceMedianSamplesYears
AMES CREEK AT HWY 20, AT SWEET HOME, OR
USGS Oregon Water Science Center
Stream 1.7 mi19 mg/L102015

Water hardness in towns near Sweet Home

TownDistanceMedianClass
Lebanon13 mi 71 mg/LModerately hard
Albany25 mi 116 mg/LModerately hard
Springfield28 mi 105 mg/LModerately hard
Corvallis31 mi 118 mg/LModerately hard
Eugene32 mi 114 mg/LModerately hard
Four Corners39 mi 30 mg/LSoft
Salem39 mi 26 mg/LSoft
Independence40 mi 27 mg/LSoft
Monmouth40 mi 36 mg/LSoft
Silverton42 mi 96 mg/LModerately hard

Linn County

Sweet Home is in Linn County, where the median is 117 mg/L (moderately hard) across 67 sites.

See all of Linn County →

Oregon

The statewide median is 71 mg/L (moderately hard) from 2,142 sites.

Oregon hardness map →

Sweet Home, OR water: common questions

Do I need a water softener in Sweet Home?

Probably not. Water measured around Sweet Home is 6.8 gpg (117 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable. If spotting bothers you, about 12,000 grains of capacity covers a 3-person home between weekly regenerations.Size it for your household →

Who supplies Sweet Home's drinking water?

The main public water system serving Sweet Home in EPA records is City of Sweet Home. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Sweet Home?

Not for anything in EPA's records: no PFAS found in EPA testing, no lead service lines reported and no health-based violations since 2016. People here who use a filter usually do it for taste, such as chlorine.Chlorine taste in tap water →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next