Water hardness in St. Helens, OR

Water in St. Helens is soft, with a median of 24 mg/L (1.4 grains per gallon) across 17 monitoring sites within 10 miles.

66% softer than the Oregon median (71 mg/L) 63rd hardest of 67 Oregon towns Population 14,437
24mg/L
1.4 grains per gallon
Soft

St. Helens tap water at a glance

  • HardnessSoft (24 mg/L, 1.4 gpg, local measurements). A water softener isn't needed.Water heater care →
  • PFAS1 found in EPA testing; every result with a federal limit was at or below it.PFAS results →
  • Lead pipesNo lead service lines reported.Details →
  • ViolationsNo health-based violations since 2016.EPA record →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 24 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 1.4 gpg (1.3 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites17
Lab samples63
Sample years2000–2025
Middle 50% of sites18–31 mg/L
Groundwater (wells, springs)23 mg/L · 12 sites
Surface water (rivers, lakes)31 mg/L · 5 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for St. Helens

Prefilled with St. Helens's measured local hardness of 24 mg/L (1.4 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in St. Helens tap water

City of ST Helens is the main public water system for St. Helens. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Nov 2024 – Aug 2025. 1 PFAS was detected.

ChemicalHighest resultDetected inEPA limit
PFBS
perfluorobutane sulfonic acid
15.5 ppt 3 of 4 samples —

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in St. Helens

City of ST Helens reported 5,226 service lines (the pipes connecting homes to the water main) in its inventory. It reported no lead or galvanized lines requiring replacement.

0lead (0%)
0galvanized requiring replacement
0unknown material (0%)
5,226not lead (100%)

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

St. Helens drinking water violations

EPA records show no health-based violations for City of ST Helens since 2016. It also had 8 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to St. Helens

SiteTypeDistanceMedianSamplesYears
Boise Cascade Clarifier Solids, D-1
Department of Environmental Quality - State of Oregon
Well 2.9 mi18 mg/L22006
Boise Cascade Clarifier Solids, D-2
Department of Environmental Quality - State of Oregon
Well 3 mi22 mg/L22006
Boise Cascade Clarifier Solids Well Ah-1
Department of Environmental Quality - State of Oregon
Well 3 mi56 mg/L22005
Boise Cascade Clarifier Solids Well Ah-10
Department of Environmental Quality - State of Oregon
Well 3 mi11 mg/L42000–2005
Boise Cascade Clarifier Solids Well Ah-11B
Department of Environmental Quality - State of Oregon
Well 3 mi12 mg/L42005
Boise Cascade Clarifier Solids Well Ah-11A
Department of Environmental Quality - State of Oregon
Well 3 mi96 mg/L22005

Water hardness in towns near St. Helens

TownDistanceMedianClass
Bethany20 mi 28 mg/LSoft
Oak Hills22 mi 37 mg/LSoft
Cedar Mill22 mi 65 mg/LModerately hard
Portland24 mi 48 mg/LSoft
Hillsboro24 mi 60 mg/LSoft
Aloha25 mi 68 mg/LModerately hard
Cornelius26 mi 82 mg/LModerately hard
Beaverton26 mi 67 mg/LModerately hard
Forest Grove27 mi 41 mg/LSoft
Fairview28 mi 44 mg/LSoft

Columbia County

St. Helens is in Columbia County, where the median is 24 mg/L (soft) across 26 sites.

See all of Columbia County →

Oregon

The statewide median is 71 mg/L (moderately hard) from 2,142 sites.

Oregon hardness map →

St. Helens, OR water: common questions

Do I need a water softener in St. Helens?

Probably not. Water measured around St. Helens is 1.4 gpg (24 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable.When a softener helps →

Who supplies St. Helens's drinking water?

The main public water system serving St. Helens in EPA records is City of ST Helens. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in St. Helens?

It depends on what you want to remove. In St. Helens, EPA testing found PFBS in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS. On the other hand, no lead service lines reported and no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next