Water hardness in Baker City, OR

Water in Baker City is moderately hard, with a median of 91 mg/L (5.3 grains per gallon) across Baker County.

28% harder than the Oregon median (71 mg/L) 20th hardest of 67 Oregon towns Population 10,225
91mg/L
5.3 grains per gallon
Moderately hard

There are not enough monitoring sites within 10 miles of Baker City, so this page uses the Baker County median.

Baker City tap water at a glance

  • HardnessModerately hard (91 mg/L, 5.3 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
  • PFASNone found in EPA's nationwide testing of the main water system.PFAS results →
  • Lead pipesNo lead service lines reported.Details →
  • ViolationsNo health-based violations since 2016.EPA record →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 91 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 5.3 gpg (5.1 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites8
Lab samples119
Sample years2010–2025
Middle 50% of sites53–135 mg/L
Surface water (rivers, lakes)91 mg/L · 8 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Baker City

Prefilled with Baker City's measured local hardness of 91 mg/L (5.3 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Baker City tap water

The City of Baker City water system is the main public water system for Baker City. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Jan 2024 – Oct 2024. No PFAS were found at or above EPA's minimum reporting levels.

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Baker City

The City of Baker City water system reported 4,574 service lines (the pipes connecting homes to the water main) in its inventory. It reported no lead or galvanized lines requiring replacement.

0lead (0%)
0galvanized requiring replacement
0unknown material (0%)
4,574not lead (100%)

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Baker City drinking water violations

EPA records show no health-based violations for the City of Baker City water system since 2016. It also had 10 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Baker City

SiteTypeDistanceMedianSamplesYears
Powder River at Hwy 7 (in Baker City)
Department of Environmental Quality - State of Oregon
River/Stream 0.5 mi59 mg/L252010–2024
Hwy 203 Pond at Hwy84
Department of Environmental Quality - State of Oregon
Lake 6 mi115 mg/L22017

Water hardness in towns near Baker City

TownDistanceMedianClass
La Grande40 mi 364 mg/LVery hard
Ontario67 mi 282 mg/LVery hard
Pendleton79 mi 112 mg/LModerately hard
Hermiston102 mi 209 mg/LVery hard
Prineville153 mi 208 mg/LVery hard
Redmond169 mi 34 mg/LSoft
The Dalles171 mi 95 mg/LModerately hard
Bend179 mi 40 mg/LSoft
Sandy221 mi 13 mg/LSoft
Troutdale228 mi 25 mg/LSoft

Baker County

Baker City is in Baker County, where the median is 91 mg/L (moderately hard) across 8 sites.

See all of Baker County →

Oregon

The statewide median is 71 mg/L (moderately hard) from 2,142 sites.

Oregon hardness map →

Baker City, OR water: common questions

Do I need a water softener in Baker City?

Probably not. Water measured around Baker City is 5.3 gpg (91 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable. If spotting bothers you, about 10,000 grains of capacity covers a 3-person home between weekly regenerations.Size it for your household →

Who supplies Baker City's drinking water?

The main public water system serving Baker City in EPA records is Baker City. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Baker City?

Not for anything in EPA's records: no PFAS found in EPA testing, no lead service lines reported and no health-based violations since 2016. People here who use a filter usually do it for taste, such as chlorine.Chlorine taste in tap water →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next