Water hardness in Sand Springs, OK
Water in Sand Springs is hard, with a median of 152 mg/L (8.9 grains per gallon) across Tulsa County.
There are not enough monitoring sites within 10 miles of Sand Springs, so this page uses the Tulsa County median.
Sand Springs tap water at a glance
- HardnessHard (152 mg/L, 8.9 gpg, local measurements). Scale on fixtures, kettles and water heaters is likely.Size a water softener →
- PFASNone found in EPA's nationwide testing of the main water system.PFAS results →
- Lead pipesNo known lead lines; 11,918 lines are still of unknown material.Check your own pipe →
- ViolationsNo health-based violations since 2016.EPA record →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 152 mg/L means at home
- Water softener: Many households here choose a softener to protect water heaters and appliances from scale.
- Dishwasher: set the water hardness to about 8.9 gpg (8.5 °dH), which is a medium-to-high hardness setting, with rinse aid.
- Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
- Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
- Water heater: flush the tank once a year to clear sediment and scale.
Size a softener for your home → Hard water and your water heater →
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Sand Springs
Prefilled with Sand Springs's measured local hardness of 152 mg/L (8.9 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Sand Springs tap water
The City of Sand Springs water system is the main public water system for Sand Springs. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Aug 2023 – May 2024. No PFAS were found at or above EPA's minimum reporting levels.
Other water systems serving parts of Sand Springs
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| Tulsa serves over 10,000 people | None detected | — | Jan 2023 – Oct 2023 |
| Washington Co RWD #3 (New,#1) serves over 10,000 people | None detected | — | Dec 2024 – Sep 2025 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Sand Springs
The City of Sand Springs water system reported 13,837 service lines (the pipes connecting homes to the water main) in its inventory. 0 are lead and 134 are galvanized lines that must be replaced, and 11,918 are still of unknown material.
EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask the City of Sand Springs water system whether your address is on its list.
Other water systems serving parts of Sand Springs
| Water system | Service lines | Total |
|---|---|---|
| Tulsa | 0 lead · 0 galvanized · 128,216 unknown | 162,343 |
| Washington Co RWD #3 (New,#1) | 0 lead · 0 galvanized · 2,651 unknown | 11,862 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Sand Springs drinking water violations
EPA records show no health-based violations for the City of Sand Springs water system since 2016. It also had 6 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.
Other water systems serving parts of Sand Springs
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| Tulsa | None | 23 |
| Washington Co RWD #3 (New,#1) | None | 4 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Sand Springs
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| Rock Creek Oklahoma Conservation Commission (State) | River/Stream | 9.7 mi | 70 mg/L | 1 | 2009 |
| Rock Creek Oklahoma Conservation Commission (State) | River/Stream | 9.7 mi | 70 mg/L | 1 | 2009 |
Water hardness in towns near Sand Springs
| Town | Distance | Median | Class |
|---|---|---|---|
| Sapulpa | 9 mi | 207 mg/L | Very hard |
| Tulsa | 13 mi | 152 mg/L | Hard |
| Jenks | 13 mi | 207 mg/L | Very hard |
| Glenpool | 15 mi | 207 mg/L | Very hard |
| Bixby | 19 mi | 212 mg/L | Very hard |
| Owasso | 20 mi | 126 mg/L | Hard |
| Broken Arrow | 21 mi | 152 mg/L | Hard |
| Coweta | 28 mi | 112 mg/L | Moderately hard |
| Claremore | 32 mi | 120 mg/L | Moderately hard |
| Okmulgee | 37 mi | 152 mg/L | Hard |
Tulsa County
Sand Springs is in Tulsa County, where the median is 152 mg/L (hard) across 7 sites.
See all of Tulsa County →Sand Springs, OK water: common questions
Do I need a water softener in Sand Springs?
Many homes here use one. Water measured around Sand Springs is 8.9 gpg (152 mg/L, measured locally), above the 7 gpg (120 mg/L) level where scale on fixtures, appliances and water heaters becomes noticeable. For a 3-person home that regenerates weekly, that means a softener of about 16,000 grains.Size it for your household →
Who supplies Sand Springs's drinking water?
The main public water system serving Sand Springs in EPA records is Sand Springs. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →
Do I need a water filter in Sand Springs?
Not for anything in EPA's records: no PFAS found in EPA testing, no lead service lines reported and no health-based violations since 2016. People here who use a filter usually do it for taste, such as chlorine.Chlorine taste in tap water →
Hardness scale
What to read next
- Do you need a water softener?Water here is hard; size a softener with our calculator.
- How to tell if your home has a lead pipe11,918 service lines here are of unknown material.
- Hard water and your water heaterHow scale affects your water heater and how often to flush.
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.