Water hardness in London, OH

Water in London is very hard, with a median of 342 mg/L (20 grains per gallon) across 39 monitoring sites within 10 miles.

24% harder than the Ohio median (276 mg/L) 14th hardest of 183 Ohio towns Population 10,533
342mg/L
20 grains per gallon
Very hard

London tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 342 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 20 gpg (19.2 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites39
Lab samples363
Sample years2000–2024
Middle 50% of sites306–353 mg/L
Groundwater (wells, springs)374 mg/L · 1 sites
Surface water (rivers, lakes)342 mg/L · 38 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for London

Prefilled with London's measured local hardness of 342 mg/L (20 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in London tap water

London City PWS is the main public water system for London. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 2 samples taken Apr 2023 – Jan 2024. No PFAS were found at or above EPA's minimum reporting levels.

Other water systems serving parts of London

Water systemPFAS detectedHighest PFOA / PFOSTested
Madison County SSWD Water District 1
serves 10,000 people or fewer
None detected — Jan 2023 – Jul 2023

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in London

London City PWS reported 4,133 service lines (the pipes connecting homes to the water main) in its inventory. 0 are lead and 39 are galvanized lines that must be replaced, and 1,128 are still of unknown material.

0lead (0%)
39galvanized requiring replacement
1,128unknown material (27%)
2,966not lead (72%)

EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask London City PWS whether your address is on its list.

Other water systems serving parts of London

Water systemService linesTotal
Mid-Ohio WSD Water District 10 lead · 0 galvanized · 25 unknown51

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

London drinking water violations

EPA records show 1 health-based violation for London City PWS since 2016, all since resolved or closed. The most recent began in Jul 2022. It also had 7 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Contaminant or ruleTypeViolationsMost recentStatus
Coliform bacteria / E. coli (Revised Total Coliform Rule)
bacteria that signal possible contamination of the system · what it means
Contaminant above legal limit 1 Jul 2022 Resolved/closed

Other water systems serving parts of London

Water systemHealth-based violationsMonitoring/reporting
Madison County SSWD Water District 1None3

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to London

SiteTypeDistanceMedianSamplesYears
London Wellfield
Division of Drinking and Ground Water (Ohio)
Well 1 mi374 mg/L22012–2014
LONDON WELLFIELD
Division of Drinking and Ground Water (Ohio)
Facility Public Water Supply (PWS) 1 mi348 mg/L42000–2005
OAK RUN DST. LONDON CORR. INST. @ OLD SPRINGFIELD RD.
Division of Surface water (Ohio) (State)
River/Stream 1.1 mi346 mg/L52011
OAK RUN DST. LONDON @ OLD XENIA RD.
Division of Surface water (Ohio) (State)
River/Stream 2.1 mi342 mg/L52011
DEER CREEK NEAR LONDON @ ST. RT. 142
Division of Surface water (Ohio) (State)
River/Stream 2.5 mi263 mg/L112011
DEER CREEK AT LAFAYETTE @ U.S. RT. 40
Division of Surface water (Ohio) (State)
River/Stream 3.4 mi278 mg/L52011

Water hardness in towns near London

TownDistanceMedianClass
Hilliard18 mi 280 mg/LVery hard
Grove City18 mi 325 mg/LVery hard
Springfield19 mi 356 mg/LVery hard
Upper Arlington22 mi 240 mg/LVery hard
Dublin22 mi 300 mg/LVery hard
Urbana22 mi 365 mg/LVery hard
Marysville24 mi 326 mg/LVery hard
Washington Court House25 mi 308 mg/LVery hard
Columbus25 mi 115 mg/LModerately hard
Worthington26 mi 237 mg/LVery hard

Madison County

London is in Madison County, where the median is 349 mg/L (very hard) across 78 sites.

See all of Madison County →

Ohio

The statewide median is 276 mg/L (very hard) from 6,849 sites.

Ohio hardness map →

London, OH water: common questions

Do I need a water softener in London?

Very likely. Water measured around London is 20 gpg (342 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 35,000 grains.Size it for your household →

Who supplies London's drinking water?

The main public water system serving London in EPA records is London City PWS. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in London?

It depends on what you want to remove. In London, the system had 1 health-based violation since 2016, for the Revised Total Coliform Rule; the utility's annual report says what was done about it. On the other hand, no PFAS found in EPA testing and no lead service lines reported. A water softener is not a filter.How to read your water quality report →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next