Water hardness in Clayton, OH

Water in Clayton is very hard, with a median of 320 mg/L (18.7 grains per gallon) across 60 monitoring sites within 10 miles.

16% harder than the Ohio median (276 mg/L) 39th hardest of 183 Ohio towns Population 13,222
320mg/L
18.7 grains per gallon
Very hard

Clayton tap water at a glance

  • HardnessVery hard (320 mg/L, 18.7 gpg, local measurements). Water softeners are common at this level.Size a water softener →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 320 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 18.7 gpg (17.9 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites60
Lab samples447
Sample years2000–2020
Middle 50% of sites291–352 mg/L
Groundwater (wells, springs)370 mg/L · 10 sites
Surface water (rivers, lakes)309 mg/L · 50 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Clayton

Prefilled with Clayton's measured local hardness of 320 mg/L (18.7 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Clayton tap water

Clayton is served by more than one water system. These systems supply ZIP codes in Clayton and were tested for PFAS ("forever chemicals") in EPA's nationwide UCMR 5 study. Check your water bill to see which one is yours.

Water systems serving Clayton

Water systemPFAS detectedHighest PFOA / PFOSTested
Dayton Public Water System
serves over 10,000 people
PFOS, PFHxS, PFPeA +2 more ND / 10 ppt Mar 2023 – Dec 2023
Englewood City PWS
serves over 10,000 people
None detected — Dec 2024 – Jun 2025
Montgomery County Water Services 2 PWS
serves over 10,000 people
PFHxS, PFOS, PFHxA +2 more ND / 7.6 ppt Jul 2023 – May 2024

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Clayton

Clayton is served by more than one water system. Their service line inventories, as reported to EPA:

Water systems serving Clayton

Water systemService linesTotal
Dayton Public Water System9,393 lead · 527 galvanized · 4 unknown64,726
Englewood City PWS0 lead · 0 galvanized · 0 unknown4,639
Montgomery County Water Services 2 PWS653 lead · 98 galvanized · 12,174 unknown30,792

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Clayton drinking water violations

Clayton is served by more than one water system. Health-based violations recorded by EPA since 2016:

Water systems serving Clayton

Water systemHealth-based violationsMonitoring/reporting
Dayton Public Water SystemNone0
Englewood City PWSNone1
Montgomery County Water Services 2 PWS24

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Clayton

SiteTypeDistanceMedianSamplesYears
STILLWATER R. @ ENGLEWOOD DAM
Division of Surface water (Ohio) (State)
River/Stream 2.3 mi328 mg/L122013
N. BR. WOLF CREEK @ WESTBROOK RD.
Division of Surface water (Ohio) (State)
River/Stream 2.6 mi328 mg/L32010
STILLWATER R. NEAR UNION @ MARTINDALE RD.
Division of Surface water (Ohio) (State)
River/Stream 2.6 mi300 mg/L92013–2020
Stillwater R. on Martindale R. nr..Union, OH
USGS Ohio Water Science Center
Stream 2.6 mi304 mg/L122000
MT-1279
USGS Ohio Water Science Center
Well 2.9 mi315 mg/L12002
STILLWATER R. DST. ENGLEWOOD @ I-70
Division of Surface water (Ohio) (State)
River/Stream 3 mi322 mg/L42013–2019

Water hardness in towns near Clayton

TownDistanceMedianClass
Englewood1 mi 322 mg/LVery hard
Trotwood5 mi 326 mg/LVery hard
Vandalia7 mi 338 mg/LVery hard
Dayton9 mi 336 mg/LVery hard
Tipp City10 mi 324 mg/LVery hard
Huber Heights11 mi 340 mg/LVery hard
Riverside12 mi 346 mg/LVery hard
Troy13 mi 324 mg/LVery hard
West Carrollton14 mi 324 mg/LVery hard
Kettering15 mi 341 mg/LVery hard

Montgomery County

Clayton is in Montgomery County, where the median is 328 mg/L (very hard) across 107 sites.

See all of Montgomery County →

Ohio

The statewide median is 276 mg/L (very hard) from 6,849 sites.

Ohio hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next