Water hardness in Statesville, NC

Water in Statesville is soft, with a median of 26 mg/L (1.5 grains per gallon) across 15 monitoring sites within 10 miles.

about the same as the North Carolina median (33 mg/L) 68th hardest of 92 North Carolina towns Population 30,220
26mg/L
1.5 grains per gallon
Soft

Statesville tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 26 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 1.5 gpg (1.5 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites15
Lab samples76
Sample years2000–2025
Middle 50% of sites17–50 mg/L
Groundwater (wells, springs)27 mg/L · 10 sites
Surface water (rivers, lakes)21 mg/L · 5 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Statesville

Prefilled with Statesville's measured local hardness of 26 mg/L (1.5 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Statesville tap water

City of Statesville is the main public water system for Statesville. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Apr 2024 – Jan 2025. No PFAS were found at or above EPA's minimum reporting levels.

Other water systems serving parts of Statesville

Water systemPFAS detectedHighest PFOA / PFOSTested
Iredell Water Corporation
serves over 10,000 people
PFPeA, PFHxA, PFOA +5 more 18.8 / 4.9 ppt Apr 2024 – Mar 2025
Energy United Water Corp
serves over 10,000 people
None detected — Mar 2025 – Dec 2025

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Statesville

City of Statesville reported 14,723 service lines (the pipes connecting homes to the water main) in its inventory. 0 are lead and 1 are galvanized lines that must be replaced, and 12,278 are still of unknown material.

0lead (0%)
1galvanized requiring replacement
12,278unknown material (83%)
2,444not lead (17%)

EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask City of Statesville whether your address is on its list.

Other water systems serving parts of Statesville

Water systemService linesTotal
Iredell Water Corporation0 lead · 0 galvanized · 613 unknown11,709
Energy United Water Corp0 lead · 0 galvanized · 0 unknown5,741

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Statesville drinking water violations

EPA records show 2 health-based violations for City of Statesville since 2016, all since resolved or closed. The most recent began in Oct 2024. It also had 1 monitoring or reporting violation (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Contaminant or ruleTypeViolationsMost recentStatus
Lead and Copper Rule Revisions
lead service line inventory and lead rule requirements
Treatment requirement not met 1 Oct 2024 Resolved/closed
Surface water treatment (filtration/turbidity)
filtration requirements that protect against microbes such as Cryptosporidium
Treatment requirement not met 1 Apr 2017 Resolved/closed

Other water systems serving parts of Statesville

Water systemHealth-based violationsMonitoring/reporting
Iredell Water Corporation15
Energy United Water CorpNone0

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Statesville

SiteTypeDistanceMedianSamplesYears
IR-190 NR STATESVILLE, NC MAFIC GNEISS
USGS North Carolina Water Science Center
Well 6.8 mi56 mg/L12014
FOURTH CRK AT SR 2308 NR ELMWOOD
NCDENR-DWQ (2nd)
River/Stream 7 mi42 mg/L122000–2001
FOURTH CRK AT SR 2308 NR ELMWOOD
North Carolina Dept of Environmental Quality NCDEQ-DWR WQX
River/Stream 7 mi44 mg/L182010–2025
IR-169 ALLISON WOODS MW-3S REG NR TURNERSBURG, NC
USGS North Carolina Water Science Center
Well 8.8 mi19 mg/L22006–2007
IR-170 ALLISON WOODS RS MW-3I TZ NR TURNERSBURG
USGS North Carolina Water Science Center
Well 8.8 mi26 mg/L22006–2007
UNNAMED TRIB TO ROCKY CREEK NR TURNERSBURG, NC
USGS North Carolina Water Science Center
Stream 8.8 mi21 mg/L12007

Water hardness in towns near Statesville

TownDistanceMedianClass
Mooresville14 mi 25 mg/LSoft
Davidson21 mi 27 mg/LSoft
Cornelius22 mi 23 mg/LSoft
Newton22 mi 15 mg/LSoft
Salisbury23 mi 52 mg/LSoft
Kannapolis25 mi 49 mg/LSoft
Hickory25 mi 15 mg/LSoft
Huntersville26 mi 28 mg/LSoft
Lincolnton30 mi 32 mg/LSoft
Concord30 mi 60 mg/LModerately hard

Iredell County

Statesville is in Iredell County, where the median is 26 mg/L (soft) across 33 sites.

See all of Iredell County →

North Carolina

The statewide median is 33 mg/L (soft) from 1,749 sites.

North Carolina hardness map →

Statesville, NC water: common questions

Do I need a water softener in Statesville?

Probably not. Water measured around Statesville is 1.5 gpg (26 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable.When a softener helps →

Who supplies Statesville's drinking water?

The main public water system serving Statesville in EPA records is City of Statesville. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Statesville?

It depends on what you want to remove. In Statesville, the system had 2 health-based violations since 2016, for the Lead and Copper Rule Revisions and the Interim Enhanced Surface Water Treatment Rule; the utility's annual report says what was done about them. On the other hand, no PFAS found in EPA testing and no lead service lines reported. A water softener is not a filter.How to read your water quality report →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next