Water hardness in Archdale, NC
Water in Archdale is soft, with a median of 45 mg/L (2.6 grains per gallon) across 17 monitoring sites within 10 miles.
Archdale tap water at a glance
- HardnessSoft (45 mg/L, 2.6 gpg, local measurements). A water softener isn't needed.Water heater care →
- PFAS8 found; the highest PFOS and PFOA result was above EPA's 4 ppt limit (a single result is not a violation).Filters that remove PFAS →
- Lead pipesNo known lead lines; 4,515 lines are still of unknown material.Check your own pipe →
- ViolationsNo health-based violations since 2016.EPA record →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 45 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 2.6 gpg (2.5 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Archdale
Prefilled with Archdale's measured local hardness of 45 mg/L (2.6 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Archdale tap water
City of Archdale is the main public water system for Archdale. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Oct 2023 – Jul 2024. 8 PFAS were detected. The highest PFOS and PFOA results were above EPA's drinking water limit (4 ppt).
| Chemical | Highest result | Detected in | EPA limit |
|---|---|---|---|
| PFOS perfluorooctane sulfonic acid | 10.6 ppt | 4 of 4 samples | 4 ppt |
| PFPeA perfluoropentanoic acid | 9.6 ppt | 4 of 4 samples | — |
| PFHxA perfluorohexanoic acid | 9.1 ppt | 4 of 4 samples | — |
| PFBA perfluorobutanoic acid | 6.6 ppt | 3 of 4 samples | — |
| PFOA perfluorooctanoic acid | 5.6 ppt | 4 of 4 samples | 4 ppt |
| PFHxS perfluorohexane sulfonic acid | 5.2 ppt | 4 of 4 samples | 10 ppt* |
| PFBS perfluorobutane sulfonic acid | 4 ppt | 3 of 4 samples | — |
| PFHpA perfluoroheptanoic acid | 3.4 ppt | 3 of 4 samples | — |
Other water systems serving parts of Archdale
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| Davidson Water INC serves over 10,000 people | None detected | — | Jan 2023 – Oct 2023 |
| City of High Point serves over 10,000 people | PFOS, PFPeA, PFHxS +3 more | 4.2 / 11 ppt | Nov 2024 – Aug 2025 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Archdale
City of Archdale reported 5,108 service lines (the pipes connecting homes to the water main) in its inventory. It reported no known lead lines, but 4,515 lines are still of unknown material.
Other water systems serving parts of Archdale
| Water system | Service lines | Total |
|---|---|---|
| Davidson Water INC | 0 lead · 0 galvanized · 0 unknown | 67,226 |
| City of High Point | 0 lead · 226 galvanized · 0 unknown | 43,340 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Archdale drinking water violations
EPA records show no health-based violations for City of Archdale since 2016. It also had 5 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.
Other water systems serving parts of Archdale
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| Davidson Water INC | None | 3 |
| City of High Point | 1 | 2 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Archdale
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| RANDLEMAN LAKE North Carolina Dept of Environmental Quality NCDEQ-DWR WQX | Lake | 4 mi | 37 mg/L | 1 | 2008 |
| RICHLAND CRK AT SR 1145 NR HIGH POINT NCDENR-DWQ (2nd) | River/Stream | 4.1 mi | 75 mg/L | 5 | 2000 |
| DEEP RIV AT SR 1129 NR HIGH POINT NCDENR-DWQ (2nd) | River/Stream | 4.5 mi | 58 mg/L | 3 | 2000–2001 |
| RANDLEMAN LAKE North Carolina Dept of Environmental Quality NCDEQ-DWR WQX | Lake | 4.6 mi | 42 mg/L | 1 | 2008 |
| DEEP RIV AT SR 1921 NR RANDLEMAN NCDENR-DWQ (2nd) | River/Stream | 5.9 mi | 68 mg/L | 8 | 2000–2001 |
| HIGH POINT LAKE North Carolina Dept of Environmental Quality NCDEQ-DWR WQX | Lake | 6.4 mi | 38 mg/L | 31 | 2007–2023 |
Water hardness in towns near Archdale
| Town | Distance | Median | Class |
|---|---|---|---|
| High Point | 6 mi | 44 mg/L | Soft |
| Thomasville | 7 mi | 62 mg/L | Moderately hard |
| Greensboro | 15 mi | 48 mg/L | Soft |
| Asheboro | 15 mi | 48 mg/L | Soft |
| Kernersville | 16 mi | 36 mg/L | Soft |
| Lexington | 19 mi | 44 mg/L | Soft |
| Summerfield | 20 mi | 30 mg/L | Soft |
| Winston-Salem | 22 mi | 44 mg/L | Soft |
| Clemmons | 25 mi | 47 mg/L | Soft |
| Elon | 29 mi | 46 mg/L | Soft |
Guilford County
Archdale is in Guilford County, where the median is 40 mg/L (soft) across 28 sites.
See all of Guilford County →North Carolina
The statewide median is 33 mg/L (soft) from 1,749 sites.
North Carolina hardness map →Archdale, NC water: common questions
Do I need a water softener in Archdale?
Probably not. Water measured around Archdale is 2.6 gpg (45 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable.When a softener helps →
Who supplies Archdale's drinking water?
The main public water system serving Archdale in EPA records is City of Archdale. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →
Do I need a water filter in Archdale?
It depends on what you want to remove. In Archdale, EPA testing found PFOS, PFPeA and PFHxA and 5 other PFAS in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS. On the other hand, no lead service lines reported and no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →
Hardness scale
What to read next
- Which water filters remove PFAS?EPA tests found 8 PFAS in Archdale's main water system.
- How to tell if your home has a lead pipe4,515 service lines here are of unknown material.
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.